Parts for Lg LDPS6762S: Section 2 Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This sensor assembly monitors conditions inside the dishwasher during the wash cycle, such as water level or water turbidity, and sends signals to the control board to adjust cycle timing and water usage. It helps the dishwasher determine when dishes are clean. Replace this part if the dishwasher runs excessively long cycles, does not fill properly, or displays sensor-related error codes.

This guide assembly is the sliding rail that supports and aligns the freezer drawer. When worn or damaged, it can cause sticking, sagging, or poor sealing; replacing it restores smooth operation and proper drawer closure.

• Supports the freezer drawer and lets it glide smoothly in and out
• Keeps the drawer square and aligned with the front panel
• Helps the drawer close fully to maintain a proper seal
• Common symptoms: drawer hard to open/close, crooked or sagging drawer, grinding/squeaking, frost from incomplete closure, visible rail damage

• Disconnect power before servicing; empty the freezer drawer
• Pull the drawer out, remove the front panel and basket as needed
• Remove mounting screws and the old guide; reuse existing hardware if applicable
• Install the new guide, then verify both sides move evenly and the drawer seals properly

A small snap-on trim cap used to cover and protect exposed fasteners or openings, restoring the appliance's finished appearance and helping keep debris out of the cavity. What it does

• Covers and conceals exposed screw heads or shaft ends for a clean look
• Helps prevent dust and lint from entering small openings
• Restores damaged or missing finish trim on the appliance
• Fits as a simple cosmetic/protective replacement — commonly used where a snap-fit cap is required

What's included

• One cap cover

Install notes

• Snap into place over the exposed fastener or opening; no special tools usually required
• Disconnect power or follow appliance safety procedures if working near electrical components
• Replace only with the matching part number to ensure proper fit

This rubber gasket seals the fill funnel area inside the dishwasher, preventing water from leaking during the fill cycle. It sits between the fill funnel and the tub or dispenser housing to create a watertight seal. Replace this gasket if you notice water leaking beneath or around the dishwasher during operation, or if the old gasket appears cracked, warped, or deteriorated.

This is a left-side slide rail assembly that supports and guides the dish rack as it rolls in and out of the dishwasher. It mounts inside the dishwasher tub and allows smooth, even movement of the rack during loading and unloading. Replace this part if the dish rack is difficult to slide, sits unevenly, or falls off its track.

Stopper roller guides and cushions dishwasher panels for smooth, quiet operation. Replace if door binds, rubs, or moves unevenly. Confirm fit with your model.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Creates a watertight seal around the dishwasher tub opening. Replace if you notice leaks, excess noise, or poor wash performance. Confirm fit with your model.

Incudes latch and safety switches.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.