Parts for Ge JGSP31GER2WG: 04 - Section4 Parts

The Round Style Oven or Broiler Igniter is an OEM replacement part for GE gas ranges and cooktops. It has a round design and is responsible for reliably igniting the gas burners with each use.  Range: 2.5 to 3.0 amps. 

Causes of a bad igniter can include wear and tear from repeated heating and cooling cycles, damage or defects in the electrical components, or issues arising from long-term exposure to high heat.

Symptoms of a bad igniter include: 

• Difficulty starting or unreliable ignition of gas burners  
• Burners failing to ignite with the press of the control knob
• Intermittent ignition problems
• Clicking sounds but no ignition

This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.

ST10-16 X 7/16"

This replacement mounting screw secures panels and trim pieces on compatible appliances to restore proper fit and reduce rattling. Use it to replace missing or damaged screws that keep covers and components fastened. What it does:

• Fastens panels, trim, and small components to the appliance frame
• Restores secure attachment to stop vibration, noise, or loose panels
• Replaces missing, stripped, or corroded screws that prevent proper closure
• Works wherever the original screw type was used for mounting or securing parts

• Disconnect power to the appliance before servicing to avoid shock
• Use the correct screwdriver or bit to avoid stripping the head
• Start threading by hand to ensure proper engagement before tightening
• Do not over-tighten; snug until secure to avoid damaging threads or panels

This small replacement clip secures cabinet insulation in place to help maintain proper thermal performance and reduce vibration. A simple, original-equipment style retainer for restoring insulation fit and keeping internal components covered. What it does:

• Holds appliance insulation against the cabinet or inner panels
• Helps prevent insulation from sagging, shifting, or falling into vents or components
• Can reduce noise caused by loose insulation and help maintain temperature control
• Commonly needed when clips are broken, corroded, or missing

• One insulation retainer clip

• Disconnect power (and water if applicable) before accessing internal panels
• Remove access panels or liners to reach the insulation area; retain fasteners
• Push or snap the retainer into the designated hole/slot; some models may require light prying or a screwdriver for removal
• Wear gloves and eye protection to avoid cuts from sharp sheet metal and insulation fibers