Parts for Ge JTP16GT1BB: 04 - Section4 Parts

Oven door won't lock for self-clean cycle? This door latch assembly secures the door during cleaning and reports lock status. Moderate DIY repair.

Convection mode not working or uneven baking? This convection heating element restores consistent heat distribution. Straightforward DIY fix.

Fix a convection fan that won't turn or hums but doesn't spin. This motor restores proper convection cooking. Moderate DIY repair with basic tools.

Oven convection fan not working or making noise? This shaft-mount fan blade restores proper airflow and cooling. Easy DIY repair in under an hour.

This upper fan cover protects the dryer's blower area and helps direct airflow so the machine vents properly and runs quietly. It replaces a cracked or damaged cover to restore safe airflow routing and reduce rubbing or rattling noises. What it does:

• Shields the blower and upper fan assembly from lint and debris
• Directs exhaust airflow through the vent path for efficient drying
• Prevents contact between the fan and cabinet that can cause noise or wear
• Helps reduce hot spots that contribute to overheating symptoms

• Disconnect power (unplug or switch off breaker) before beginning any repair
• Access typically requires removing the dryer cabinet top or rear panel; follow your model's disassembly steps
• Handle edges and surrounding components carefully—sharp sheet metal may be present
• Inspect nearby seals, mounting clips, and the blower wheel for damage while replacing the cover

Replacement mounting screw for securing panels, brackets, and components inside your appliance. Needed when original screws are stripped or missing.

Replacement screw for securing panels, brackets, and internal components. Needed when original hardware is stripped, missing, or damaged during repairs.

Replacement mounting screw for cooktops and ranges. Secures burner components, brackets, or panels. Needed when screws are stripped, lost, or damaged.

Black hex washer screw for securing range components like door trim, control panels, and internal brackets. Replace missing or stripped screws during repairs.

Hardware washer kit for various appliances. Includes 12 washers for securing components during installation or repair. Replace worn or missing washers.

This is a flat metal washer used to secure fasteners and maintain proper spacing on the appliance. It provides a simple, durable spacer that helps keep components aligned and fasteners snug for reliable performance. What it does:

• Acts as a spacer to maintain correct clearance between parts
• Distributes load from a fastener to prevent pull-through or damage
• Helps keep bolts and screws from loosening under vibration
• Can reduce noise or vibration caused by loose or misaligned components

• Disconnect power (and water if applicable) before beginning any repair.
• Use the correct fastener and orientation for reassembly; replace any damaged hardware.
• Tighten fasteners snugly but avoid over-torquing;
• If the appliance shows continued vibration, noise, or instability after replacing the washer, further inspection of mounting hardware and suspension components is recommended.

Replacement mounting nut secures components and panels inside your electric range or wall oven. Replaces stripped, lost, or damaged nuts causing loose parts.