Parts for Lg LFD22860ST / ASTCLGY: Section 4 Parts

This is a genuine replacement screw used to secure appliance panels and components. It restores proper fastening so panels and assemblies stay aligned and operate safely. What it does:

• Fastens panels, brackets, and small assemblies to maintain structural integrity
• Replaces missing or stripped screws that cause rattling or loose parts
• Helps stop vibration-related noise when used in its original mounting locations
• Matches the OEM fit to ensure proper alignment and clearance

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread or component damage
• Disconnect power to the appliance before working on electrical components
• Replace all matching fasteners for even fit

This refrigerator door gasket creates an airtight seal between the door and cabinet to keep cold air in and moisture out. Replace a worn or torn seal to restore cooling performance, reduce frost, and prevent temperature fluctuations.

• Forms a continuous seal around the door perimeter to minimize air leaks
• Helps maintain proper temperatures and humidity inside the refrigerator
• Common failure signs: gaps, tears, or hardened/warped corners
• Symptoms may include doors not closing flush, condensation or frost buildup, and longer run times

What's included: 1 door gasket assembly Installation notes:

• Unplug the refrigerator before servicing
• Warm the new gasket in hot water or with a hair dryer on low to improve flexibility
• Pull the old gasket from the retainer channel; press the new gasket into the channel, starting at the corners
• Close the door and check for uniform contact all around; re-seat and adjust as needed

This name plate is the exterior emblem that mounts to the appliance's front panel. It replaces a missing, cracked, or faded badge to restore a clean, factory look and cover the designated trim area.

• Attaches to the outer panel to display brand/series identification
• Restores a finished appearance where the original emblem sits
• Direct replacement for a lost, damaged, or worn badge
• Typical symptoms: missing emblem, loose or broken tabs, peeling, or discoloration

• Disconnect power before servicing the appliance
• Carefully remove the old emblem; release any tabs from behind or peel away remaining adhesive
• Clean and dry the mounting surface; remove all residue for best fit
• Align with the recess/holes and press evenly until fully seated

The Holder Gasket is an OEM part for LG refrigerators. This gasket creates a tight seal between the holder and the refrigerator's interior, preventing air leaks and maintaining optimal cooling efficiency.

Common causes of a bad gasket include wear and tear over time, exposure to extreme temperatures, or accidental damage during maintenance or cleaning.

Symptoms of a bad gasket include:

• Air leaks leading to temperature fluctuations
• Increased energy consumption
• Frost or condensation buildup inside the refrigerator
•  Difficulty maintaining consistent temperatures

This OEM LG part is also compatible with Sears/Kenmore models.

The Gasket Holder is an OEM replacement part for LG refrigerators. It is a mount located around refrigerator doors that secures the gaskets in their tracks. About 37.5" long

Potential failure causes relate to consistent flexing and impact stresses warping holder material over many years. Mineral buildup inhibiting a flush seal is also possible.

Symptoms involve:

• Cold air infiltration from gaps where gaskets no longer fit tightly
• Condensation or frost accumulated on external door panels
• Ice buildup inside due to insufficient insulation performance
• Gaskets detaching from holder tracks rendering them useless

This OEM LG part is also compatible with some Sears/Kenmore models.

The Gasket Holder is an OEM replacement part for LG refrigerators. It is a mount located around refrigerator doors that secures the gaskets in their tracks. About 37.5" long

Potential failure causes relate to consistent flexing and impact stresses warping holder material over many years. Mineral buildup inhibiting a flush seal is also possible.

Symptoms involve:

• Cold air infiltration from gaps where gaskets no longer fit tightly
• Condensation or frost accumulated on external door panels
• Ice buildup inside due to insufficient insulation performance
• Gaskets detaching from holder tracks rendering them useless

This OEM LG part is also compatible with some Sears/Kenmore models.

The Gasket Holder is an OEM part for LG refrigerators. This part holds the door gasket in place, ensuring a tight seal around the refrigerator or freezer door. 

Over time, the gasket holder can become warped or damaged due to frequent use, temperature fluctuations, or accidental impacts. 

Symptoms of a bad Gasket Holder include:

• Loose or sagging door gasket
• Noticeable gaps between the gasket and the door frame
• Difficulty in maintaining consistent refrigerator temperatures
• Increased condensation or frost inside the appliance

This OEM LG part is also compatible with some Kenmore models.

The Gasket Holder is an OEM replacement part for LG refrigerators. It is inside the freezer door and functions to securely seal in cold air. The holder provides a mounting point and compression fit for the door gasket, preventing air leakage along the perimeter.  

Symptoms of a bad gasket holder include:

• Cold air escaping around the door seal 
• Frost or moisture buildup near the gasket area
• The door not shutting tightly 

Note: About 38.5" long

Over time, the holder's mounting points can warp or weaken from repeated opening and closing of the freezer door. This allows for gasket movement and compromised sealing.

This replacement is compatible with Sears/Kenmore models as well.

The Left Door Closing Cam is an OEM replacement part for LG refrigerators. It is a mechanical component located on the inside of the refrigerator door that works with the door closing mechanism. The door closing cam helps ensure the refrigerator door closes and seals properly each time.

Causes of a bad door closing cam can include wear and tear over time, damage from repeatedly closing the heavy refrigerator door, or misalignment affecting the door seal.  

Symptoms of a bad door closing cam include:

• The refrigerator door not sealing tightly when closed 
• Difficulty closing or opening the door
• Excessive movement or wobbling of the door 
• Cool air escaping around the door seal

This OEM LG part is also compatible with Sears/Kenmore fridges.

The Door Closing Cam is an OEM replacement part for LG refrigerators. Positioned at the lower hinge of the right side refrigerator door, this cam assists in the smooth and controlled opening and closing of the door. It ensures that the door closes securely to maintain the internal temperature and energy efficiency of the appliance.

Causes for a malfunctioning Door Closing Cam can include wear and tear from frequent use, damage incurred from forceful opening or closing of the door, or issues with the alignment that prevent the cam from operating smoothly.

Symptoms of a bad Door Closing Cam include:

• The refrigerator door not closing securely
• A sagging or misaligned door
• Unusual noises when opening or closing the door
• Difficulty in opening or a lack of smooth motion when closing the door

This OEM LG part is also compatible with Sears/Kenmore models.

The Door Basket Assembly is an OEM part for LG refrigerators. It is designed to provide additional storage space on the refrigerator door, allowing for the convenient organization of smaller items like condiments, beverages, and snacks. The bin has dimensions of approximately 13 inches in width, 3-1/2 inches in height, and 7 inches in depth. 

Causes of a bad door basket assembly can include wear and tear over time, damage from overloading, or accidental impacts that can crack or break the basket.

Symptoms of a bad door basket assembly include:

• Cracks or visible damage to the basket
• Difficulty in securely holding items
• The basket detaching from the door

This OEM LG part is also compatible with Sears/Kenmore.

The Door closer is an OEM part for LG refrigerators, this part prevents the refrigerator door from swinging open too widely. By limiting the door's range of motion, the Door Stop ensures that the door opens smoothly and safely, contributing to the longevity of the appliance and maintaining the aesthetic integrity of your kitchen space.

Causes of a bad Door closer can stem from physical damage, wear and tear over time, or loosening of the component due to repeated use. 

Symptoms of a bad Door closer include:

• The refrigerator door swinging open too far
• Damage or marks on adjacent walls or furniture from the door hitting them
• Increased wear on the refrigerator's hinges due to uncontrolled door movement

This OEM LG part is also compatible with some Kenmore models.

RAIL,SLIDE-LEFT

RAIL,SLIDE-RIGHT

This connector secures and transmits motion between the drawer drive and the sliding assembly, restoring smooth drawer movement and alignment. It's a direct-fit replacement that helps fix sticking, slipping, or non-moving drawers. What it does:

• Couples the drawer drive mechanism to the sliding gear, allowing the drawer to open and close reliably
• Replaces worn or broken connector teeth or mounts that cause skipping or jammed operation
• Helps correct uneven or noisy drawer movement caused by damaged linkage
• Restores proper engagement so the drawer responds to normal open/close controls

• One connector as shown

• Disconnect power to the appliance before servicing to avoid electrical shock or injury
• Inspect surrounding gears, tracks, and mounting points; replace any damaged parts for best results
• Basic hand tools are typically required; handle plastic gears carefully to avoid further damage

This is a ring intended for use in refrigerators. The ring is used to adjust the height of the door. Genuine OEM replacement rings are necessary for the repair to ensure a proper fitting.If the refrigerator door no longer opens or closes easily, or if it is not sealing properly, the rings may need to be replaced. Visual inspection can determine if there are problems with the refrigerator door rings. Make sure to unplug the device before starting any of the disassemblies of the machine. Wear gloves.This ring is an authentic OEM replacement part. It is sold as an individual unit. The ring is made of high-quality, durable materials. The replacement piece is sourced directly from the manufacturer. It can be installed in several models of refrigerators. The genuine OEM replacement ring is compatible with refrigerators produced by both LG and Kenmore.

This replacement hinge assembly supports and pivots the refrigerator door. Replacing a worn or bent hinge restores smooth door movement and proper alignment so the gasket can seal correctly to help maintain performance. What it does:

• Provides the pivot point for the door to open and close
• Supports the door's weight to keep it aligned
• Helps the door gasket seal evenly against the cabinet
• May correct issues such as door sagging, rubbing, popping, or not closing/sealing fully

• One hinge assembly

• Unplug the refrigerator and remove items from the affected door
• Support the door while removing hinge screws; note the orientation of any spacers/bushings
• Transfer any reusable hardware from the old hinge to the new assembly
• Reinstall and tighten fasteners; verify door is level and check gasket seal

The Hinge Bushing is an OEM part for LG refrigerators. It serves as a crucial component in the door hinge mechanism, ensuring smooth and stable operation when opening and closing the refrigerator door.

You should replace this hinge bushing if it becomes worn out or damaged. Common causes of a bad hinge bushing include constant use leading to wear and tear, misalignment of the door, or physical damage due to impact.

Symptoms of a bad hinge bushing include:

• Difficulty in opening or closing the door
• The door sagging or not aligning properly
• Unusual noises like squeaking or grinding when the door is moved

This OEM LG part is also compatible with Sears/Kenmore.