Parts for Lg LRFC22750TT / ATICLGY: Section 4 Parts

The Door Gasket is an OEM part for LG refrigerators. This gasket seals the refrigerator door, ensuring a tight closure to maintain the internal temperature and prevent cold air from escaping. By creating an airtight seal, the door gasket helps keep food fresh and reduces energy consumption.

You should replace the door gasket if it becomes worn or damaged. Causes of a bad door gasket can include wear and tear over time, damage from repeated opening and closing of the door, or warping due to temperature fluctuations.

Symptoms of a bad door gasket include:

• Warm spots inside the refrigerator
• Excessive condensation or frost buildup
• The refrigerator door not closing properly
• Increased energy bills

This OEM LG part is also compatible with Sears/Kenmore models.

This name plate is the exterior emblem that mounts to the appliance's front panel. It replaces a missing, cracked, or faded badge to restore a clean, factory look and cover the designated trim area.

• Attaches to the outer panel to display brand/series identification
• Restores a finished appearance where the original emblem sits
• Direct replacement for a lost, damaged, or worn badge
• Typical symptoms: missing emblem, loose or broken tabs, peeling, or discoloration

• Disconnect power before servicing the appliance
• Carefully remove the old emblem; release any tabs from behind or peel away remaining adhesive
• Clean and dry the mounting surface; remove all residue for best fit
• Align with the recess/holes and press evenly until fully seated

This genuine door gasket assembly creates a tight seal around the appliance door to prevent air and moisture loss, helping the appliance maintain temperature and operate efficiently. What it does:

• Seals the door opening to stop air leaks and reduce energy loss
• Helps prevent condensation, spills, and drafts from escaping the cabinet
• Restores proper door closure and improves temperature consistency
• Commonly replaced when the existing gasket is torn, warped, or no longer seals

What's included: One door gasket assembly as shown Install notes:

• Disconnect power (and water, if applicable) before starting any repair
• Remove the door or access trim to access the gasket mounting channel
• Inspect the door flange and gasket seating surface; clean debris before installing the new gasket
• Use only manufacturer-recommended fasteners and replace any damaged retainers; test door operation and seal after installation

Replace your cracked, broken, or missing refrigerator door bin. Provides convenient storage for condiments, beverages, and snacks on the door.

Plastic door stop that limits refrigerator door swing range. Replaces broken, cracked, or missing stoppers causing doors to swing too wide or close improperly.

This is a ring intended for use in refrigerators. The ring is used to adjust the height of the door. Genuine OEM replacement rings are necessary for the repair to ensure a proper fitting.If the refrigerator door no longer opens or closes easily, or if it is not sealing properly, the rings may need to be replaced. Visual inspection can determine if there are problems with the refrigerator door rings. Make sure to unplug the device before starting any of the disassemblies of the machine. Wear gloves.This ring is an authentic OEM replacement part. It is sold as an individual unit. The ring is made of high-quality, durable materials. The replacement piece is sourced directly from the manufacturer. It can be installed in several models of refrigerators. The genuine OEM replacement ring is compatible with refrigerators produced by both LG and Kenmore.