Parts for Thermador PRD486EDPG/01: Small Oven Parts

The Lamp is an OEM part for Bosch ranges and ovens. The range lamp provides visibility when viewing food through the oven window or checking on items cooking on the stove.

Causes of a bad range lamp can include normal wear and tear over time, as well as accidental damage from impact or handle mishandling.

Symptoms of a bad range lamp include:

• Diminished light that does not adequately illuminate the cooking space
• Flickering or unstable illumination
• A burned out or broken bulb

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

The temperature sensor is an electronic probe that monitors internal appliance temperature and reports it to the control so it can regulate operation. Replacing a failed sensor restores more accurate temperatures and can clear temperature-related error codes. What it does:

• Senses internal temperature via resistance changes and sends the signal to the electronic control
• Helps the control reach and maintain the set temperature during operation
• Common failure symptoms: too hot/cold, won't reach set temp, long/short cycles, temperature error codes
• Can cause preheat to stall or the unit to shut off early (model dependent)

• Includes: 1 temperature sensor

• Disconnect power at the breaker before servicing
• Location and access vary by model; typically mounts with screws or a clip and connects to a 2-wire harness
• Handle the connector and wiring carefully; route and secure away from hot or moving parts
• After installation, clear stored errors and run a test cycle to proper readings

Heating element assembly that restores your appliance's ability to heat water or air so cycles reach the correct operating temperature. Use it to replace a failed heater that prevents proper drying, sanitizing, or heating performance. What it does:

• Heats water or air during operation so wash, sanitize, and dry cycles reach the intended temperature.
• Common repair for no-heat, poor drying, or cycles that fail to reach or maintain temperature.
• Works with the appliance's control and thermal cutoff to deliver regulated heat when called for.
• Replace if the element is visibly damaged, shows an open circuit on a multimeter, or triggers thermal faults.

• Always disconnect power (unplug or switch off breaker) before servicing the appliance.
• Handle carefully; terminals and mounting brackets can be sharp or fragile. Avoid bending element tubing.
• After installation, restore power and run a short diagnostic or cycle to confirm proper heating and no error codes.

This genuine dishwasher tub heating element warms wash water and helps dry dishes by raising cycle temperatures. It's a direct-replacement part for Bosch dishwashers that restores proper wash and drying performance when the heater fails. What it does:

• Heats wash water so detergent cleans effectively and soils are removed
• Assists in the drying phase by raising interior temperature for better evaporation
• Commonly replaced when the dishwasher does not heat, leaves dishes wet, or shows related cycle faults
• Works as the primary thermal element for the dishwasher's wash/dry functions

• One heating element

• Disconnect electrical power at the breaker before starting any work
• Replace only with the exact part specified for your model; handle ceramic/metal elements carefully to avoid damage
• Inspect and reseat gaskets and mounting hardware; ensure connections are tight and wires are undamaged
• After installation, restore power and run a short cycle to ensure proper heating and operation