Parts for Frigidaire FAK190GN0D: 07 - System And Automatic Defrost Parts

This part has been discontinued by the manufacturer and is no longer available.

This compressor overload is a replaceable start-protection device that helps prevent compressor overheating and electrical damage. Replacing a failed overload restores reliable compressor starting and helps the refrigerator return to normal cooling. What it does:

• Protects the compressor by interrupting current if the compressor draws excessive current or overheats.
• Works with the compressor start relay to help the compressor start and run normally.
• Common symptoms of a failing overload: refrigerator not cooling, compressor won't start or hums, repeated clicking or tripping.
• Small, service-replaceable part located at the compressor terminals.

• Disconnect power to the appliance before accessing the compressor and its terminals.
• Handle wiring and terminals carefully; note lead locations or take a photo before removal to ensure correct reinstallation.
• If mounting hardware or connector types differ, do not force parts.

Includes service line.

This rubber compressor mounting grommet cushions and isolates the compressor to reduce vibration and noise that can transfer to the cabinet. It helps maintain stable compressor positioning for quieter, smoother operation. What it does:

• Absorbs compressor vibration to lower noise and rattling
• Dampens movement that can cause abrasion or wear on mounting hardware
• Helps maintain proper alignment of the compressor assembly
• Common symptom: excessive buzzing, vibration, or rattling from the back of the appliance

• Always disconnect power to the appliance before servicing.
• Support the compressor before removing mounts to prevent shifting or damage.
• Inspect surrounding mounts and hardware; replace any worn or damaged pieces.

Galvanized Steel

This aluminum strap secures the defrost heater firmly against the evaporator coil to maintain proper contact during defrost. Correct contact improves heat transfer so frost melts evenly and helps prevent recurring ice buildup on the evaporator.

• Secures the defrost heater to the evaporator for proper contact and heat transfer
• Promotes complete, even defrosting across the evaporator coil
• Helps reduce repeat frost/ice accumulation caused by a shifted or loose heater
• Typical clues include a loose heater, uneven frost pattern, or rattling near the evaporator

• Disconnect power and allow ice to melt before accessing the evaporator
• Use care around sharp fins and fragile refrigerant tubing; do not puncture or deform the coil
• Position the heater per your model's parts diagram and tighten the strap for firm, even contact
• Verify wiring is routed clear of the fan and moving parts before reassembly