Tappan Range Housing Or Cover

This outer housing cover replaces a damaged or missing trim piece to protect internal components and restore the appliance's finished appearance. It fits as the exterior cover piece found on the original unit. What it does:

• Protects internal components from dirt, spills and accidental contact
• Conceals wiring and mounting points for a clean, finished look
• Prevents small items from entering sensitive areas that could cause faults
• Restores appearance after panel damage or wear

• One outer housing cover

• Disconnect power to the appliance before starting any service
• Follow the manufacturer's service instructions and keep track of fasteners
• Use basic hand tools; avoid flexing the part to prevent cracking

This replacement cover fits the rod end of the light switch assembly to protect the switch and help keep the door light operating correctly. It restores the correct actuator engagement and prevents dust or debris from impacting switch function. What it does:

• Replaces a worn, cracked, or broken rod end cover that can prevent the light switch from engaging
• Protects the light switch actuator from dirt and moisture that can cause intermittent lighting
• Helps restore proper door-actuated switch operation and consistent interior lighting
• Commonly used when the switch actuator no longer contacts or aligns with the door rod

• Disconnect power to the appliance before starting any repair to avoid electrical shock
• Access may require removing a door or interior trim panel; keep fasteners organized
• Inspect the light switch and actuator rod for damage and replace any damaged components as needed

This rear wall shield protects the appliance's interior back panel from heat, moisture and component contact, helping keep internal parts secure and preventing damage. It's a simple replacement that restores proper protection behind the cabinet. What it does:

• Acts as a barrier between internal components and the cabinet rear to prevent wear or heat damage
• Helps direct airflow and keeps wiring/components clear of the rear wall
• Reduces risk of debris or moisture reaching sensitive parts
• Can resolve symptoms like visible damage or gaps at the back panel and rattling from loose rear insulation

• One rear wall shield

• Disconnect power (and gas, if applicable) before starting any repair
• Handle carefully; edges may be sharp—use gloves and eye protection
• Remove outer panels as needed to access and align the shield, then secure with existing fasteners

This cover is a molded trim piece that conceals and protects the appliance's internal components while restoring a finished appearance. It replaces a cracked, broken or missing cover to keep wiring and fasteners out of sight and reduce dust entry. What it does:

• Covers and protects control or component openings to prevent debris and accidental contact
• Restores cosmetic appearance when the original cover is cracked, warped or missing
• Helps maintain a proper fit of adjacent panels and trim
• Can eliminate rattling or vibration caused by a damaged cover

• One cover

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Basic hand tools typically required; remove surrounding trim or screws for access
• Align tabs and screw holes carefully—do not force the part into place
• If clips or mounting hardware are damaged, replace them before final installation