Tappan Range Wire, Harness, Power Cord

This kit includes a surface element receptacle block and wiring harness that connects a burner element to the range's electrical system. It transfers power from the terminal block to the heating element on the cooktop. Replace this kit if your surface burner heats intermittently, fails to heat at all, or you see scorching or burn marks around the receptacle connections.

Replacement power cord for ovens and ranges. Installs at the rear panel to restore electrical connection. Needed when original cord is frayed or damaged.

This kit includes a wiring receptacle and harness that connects a surface burner element to the range's electrical system. The receptacle plugs into the terminal ends of the heating element and routes power from the control switch. Replace this kit if the receptacle is burned, melted, or corroded, or if a surface burner heats intermittently or fails to heat at all.

Wire harness assembly that connects electrical components in your electric range. Replaces a damaged, frayed, or worn harness to restore safe connections.

Replacement wire harness for ranges. Connects electrical components inside your range. Order if wiring is damaged, frayed, melted, or connections are loose.

Main wiring harness for gas ranges. Connects control board to oven components. Replace if wires are frayed, damaged, or causing connection issues.

This main wiring harness connects a refrigerator's control board and key components, providing organized power and signal routing so controls, lights and the compressor operate reliably. Replaces a damaged or burned main harness for restored electrical continuity. What it does

• Routes power and signal connections between the control board, lights, compressor and sensors.
• Prevents intermittent operation caused by loose, corroded or broken wiring.
• Can stop failures such as no lights, components not running, or control errors when the harness is the fault.
• Keeps wires organized and secured to avoid chafing and shorting.

• One main wiring harness as pictured.

• Disconnect power before servicing to prevent shock or damage.
• Compare the new harness to the original and route wires the same way; replace any damaged clips or grommets.
• Reconnect all terminals fully; loose connectors can cause intermittent faults.

Replace your range's main wiring harness if connections are damaged, wires are frayed, or insulation is cracked. Connects electrical components throughout the unit.

Replace your range's main wiring harness if the original is damaged, frayed, or has burnt connectors. This internal wire harness connects electrical components.

Main wiring harness for electric ranges. Connects control board to heating elements and components. Replace if wires are frayed, damaged, or melted.

Main wire harness for gas ranges. Connects electrical components throughout the unit. Replace if wiring is damaged, frayed, or connections are loose.