Thermador Blower Wheel Or Fan Blade

The Evaporator Fan Motor Blade is an OEM part for Whirlpool refrigerators. It is a crucial component of the refrigerator's cooling system, attached to the evaporator fan motor to circulate air over the evaporator coils. This circulation helps distribute cold air throughout the refrigerator and freezer compartments, ensuring consistent temperatures and efficient operation.

Symptoms of a bad Evaporator Fan Motor Blade include:

• Unusual noise coming from the fan area, indicating the blade may be hitting another component or is unbalanced,
• Insufficient cooling in the refrigerator or freezer compartments,
• The refrigerator running longer than usual to maintain the desired temperature.

Causes of evaporator fan motor blade failure typically include physical damage from interference with other components, wear from continuous use, or buildup of ice or debris that unbalances the blade.

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This condenser fan blade mounts to the fan motor and pulls air across the condenser coil and compressor. Replacing a cracked or warped blade restores airflow so your refrigerator cools efficiently and the compressor runs at a safe temperature.

• Circulates air through the condenser coil and over the compressor to remove heat
• Helps maintain cooling performance and stable system pressures
• Common symptoms: weak or no airflow at the rear/base, rattling or scraping noises, wobble/vibration, visible cracks or missing fins, warmer-than-normal compartments or hot cabinet sides
• Works with the condenser fan motor and shroud; typically replaced when the hub is stripped or the blade is damaged

• Disconnect power and pull the refrigerator out; remove the rear access cover near the compressor
• Note blade orientation and depth on the motor shaft before removal
• Pull the old blade straight off; press the new blade onto the shaft until fully seated and ensure it spins freely with proper shroud clearance
• Reinstall the cover, restore power, and verify strong, quiet airflow

This impeller is the rotating pump component that moves water through the appliance, restoring spray and circulation performance. Replacing a worn or damaged impeller helps resolve poor wash/rinse results and noisy pump operation. What it does:

• Drives water flow inside the pump housing to maintain proper spray and circulation.
• Can cause weak sprays, poor cleaning, or unusual pump noises when worn or broken.
• Fits the CW H98/HB style pump assembly and interfaces with the pump shaft and housing.
• Designed for direct OEM-fit replacement where this impeller is specified.

• Recommended for users comfortable disassembling pump housings; refer to your service manual for specific steps.
• Disconnect power and turn off the water supply before starting service.
• Inspect the pump housing, seals, and shaft for wear; replace any damaged components to prevent repeat failure.
• Use appropriate tools and handle plastic parts carefully to avoid cracking.

This fan blade replaces a damaged or worn blower blade to restore proper airflow and reduce noise. It helps the appliance circulate air efficiently so cooling and ventilation perform as intended. What it does:

• Moves air across the evaporator/heatsink or within the appliance cabinet to support cooling and ventilation
• Restores full airflow when the original blade is cracked, warped, or missing
• Helps reduce rubbing, vibration, and unusual fan noise caused by damaged blades
• Prevents motor strain that can occur when an imbalanced or broken blade is used

• Disconnect power to the appliance before beginning any repair
• Handle the blade carefully to avoid bending the impeller fins
• Inspect the motor shaft, set screw, and mounting hardware; replace any damaged fasteners