Thermador Leg Or Foot

The Leveling Foot is an OEM part for Bosch dishwashers. It is designed to provide stability by allowing you to adjust the height of the dishwasher, ensuring it is level on uneven flooring.

Causes of a bad leveling foot can include wear and tear over time, damage from excessive force or impact, or thread stripping from frequent adjustments.

Symptoms of a bad leveling foot include:

• The dishwasher rocking or wobbling during operation
• Difficulty in achieving a level position
• Increased noise or vibration when the dishwasher is running

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Note: Kit includes 4 feet and a tube of RTV with instructions.

This front leveling leg supports and adjusts the appliance at the front, helping it sit stable and truly level. Replace a damaged or missing leg to restore proper height, stability, and smooth door alignment during everyday use.

• Provides height adjustment at the front to level the appliance
• Helps prevent rocking, vibration, and rattling
• Maintains correct cabinet/door alignment for proper operation
• Replace if the foot is cracked, stripped, missing, or won't adjust
• Common signs: unit wobbles, sits unevenly, or is difficult to level

• Disconnect power; if applicable, shut off water or gas. Pull the appliance forward and remove the toe-kick/access panel for clearance.
• Protect the floor; tilt or raise the front slightly to reach the leg.
• Unscrew the damaged leg; thread the new leg in by hand to avoid cross-threading.
• Adjust height until level front-to-back and side-to-side; verify stability before returning to service.

This replacement roller fits the front or rear position of a slide mechanism, restoring smooth, even movement and reducing noise when a wheel is worn or broken. It helps racks or drawers glide properly and stay aligned. What it does:

• Provides low-friction rolling support for the slide track
• Helps slide-out assemblies move freely without binding or scraping
• Worn or damaged rollers can cause sticking, squeaking, or uneven travel
• Restores proper alignment and smooth operation when replaced

• 1 roller assembly

• Disconnect power and allow the appliance to cool before servicing
• Remove the slide-out assembly; note roller orientation and hardware
• Transfer/reuse existing screws, clips, or retainers as required
• Do not lubricate unless the manufacturer specifies a lubricant

This grate foot assembly installs on the underside of a gas cooktop or range grate to cushion and stabilize it. Replacing worn or missing feet helps protect the surface and keeps cookware level while you cook.

• Cushions contact between the grate and cooktop surface
• Helps keep the grate from sliding and reduces rattling
• Maintains proper grate height for stable, level cookware
• Common symptoms: wobbling/rocking grate, missing or hardened feet, scratches on the surface

• Allow the cooktop and grates to cool completely before servicing
• Remove the grate, pull off the old foot, and clean the mounting area
• Press the new foot firmly into place; if your model uses an adhesive or retainer, follow the manufacturer's cure time before using the burners
• For best results, replace all feet on a grate at the same time and it sits flat

This roller set replaces worn or broken rack wheels so your dishwasher rack slides smoothly and stays aligned. It restores quiet, stable rack movement and prevents the rack from catching or tipping when pulled. What it does:

• Replaces damaged or missing rack wheels to restore smooth sliding action
• Helps keep the rack aligned and prevents it from sticking or catching
• Reduces noise and wobble when opening or closing the rack
• Works with the rack's axle to support proper rolling motion

• Disconnect power and turn off water supply before starting repairs
• Remove the dish rack to access and replace the rollers; keep track of axle and clips
• Use basic hand tools; inspect the axle and track for debris or damage before reassembly