Thermador Range Trim

This is the front-facing control panel facia that covers the area where the knobs and controls are located on the range. It provides the finished exterior surface and houses or supports the control interface components. Replace this panel if it is cracked, discolored, heat-damaged, or if the labeling has worn off, making it difficult to read settings.

Decorative trim frame for microwave exterior. Replaces cracked, chipped, or missing trim pieces. Installs around the microwave door or control panel.

Color: Stainless

This is a structural frame that surrounds and supports the oven door, providing rigidity and a finished appearance. It holds the door glass and inner panel components securely in place. Replace this frame if it is bent, cracked, or damaged, which can cause the door to fit poorly, allow heat to escape, or create an uneven seal against the oven opening.

Welded bullnose trim assembly for gas ranges. Installs on the front edge of the cooktop. Replace if cracked, chipped, or discolored to restore appearance.

Replacement kick panel trim for your range. Covers the base opening beneath the oven door. Replace if cracked, chipped, discolored, or missing.

Covers the gap beneath your 30-inch range, hiding the cabinet opening under the oven. Replace this lower front toe panel when cracked, dented, or missing.

This is a door frame that surrounds and supports the oven door glass and inner panel on a range. It provides structural rigidity and a finished appearance to the door assembly. Replace this frame if it is cracked, warped, or damaged, which can affect the door's seal and allow heat to escape during cooking.

This is a door frame that surrounds and secures the oven door glass on a range or wall oven. It provides structural support and a finished appearance to the door assembly. Replace this frame if it is warped, cracked, corroded, or if the door glass has become loose or poorly seated.

Gray door glass trim support for ranges and wall ovens. Replaces cracked, broken, or missing trim pieces that secure glass panels on oven doors.

This right-side front frame piece replaces a damaged or worn exterior support on the appliance front. It restores proper panel alignment and helps maintain a flush fit and reliable door/panel operation. What it does

• Replaces the right front side frame that supports the appliance's front panel and trim
• Restores proper alignment to reduce gaps, rubbing or uneven panel fit
• Helps eliminate rattling or vibration caused by a broken or bent frame section
• Prevents further wear to adjoining panels and fastening points when intact

• Disconnect power to the appliance before starting any repair
• Basic hand tools (screwdriver, nut driver) may be required; keep fasteners for reuse
• Handle edges carefully—metal parts can be sharp