Thermador Range Trim

Decorative trim piece that frames the control panel on your gas range. Replace if the original is cracked, chipped, discolored, or missing for a clean finish.

This left side trim piece replaces a damaged or missing side trim to restore the cabinet edge and finished appearance of the appliance. It helps maintain a flush fit and clean look along the refrigerator side. What it does:

• Covers and protects the exposed edge of the cabinet for a finished appearance
• Restores proper trim alignment to reduce gaps and rubbing against adjacent surfaces
• Replaces cracked, dented or missing trim that detracts from the appliance finish
• Helps maintain a uniform seal and appearance after service or collision repair

• Always unplug the appliance or turn off power before starting cosmetic or trim repairs
• Installation typically involves removing any adjacent molding or fasteners and snapping or fastening the trim into place; keep original fasteners if reusing
• Handle edges carefully to avoid cuts or damaging adjacent panels

This right side trim is a molded exterior trim piece that restores the appliance's finished look and covers the cabinet edge. It keeps the side of the unit looking clean and replaces damaged or missing trim for a factory appearance. What it does:

• Replaces a cracked, chipped, or missing right-side exterior trim piece
• Covers and protects the cabinet edge from scrapes and dirt
• Restores the original appearance for a seamless door/cabinet fit
• Helps prevent gaps that can collect debris around the appliance edge

• Remove power and empty surrounding area for safe access before starting
• Typical install uses existing clips or screws—retain original fasteners when possible
• Handle trim carefully to avoid scratching the finish during installation
• If trim does not align, inspect mounting clips for damage

Lower front trim frame for ranges. Replaces cracked, bent, or missing trim pieces along the bottom front edge. Restores appliance appearance.

This is the right-side front trim piece for the appliance door—a finished stainless steel replacement that restores the door's appearance and protects the door edge from damage. What it does:

• Covers and finishes the right front edge of the door for a factory look
• Protects the door edge from chips, nicks and everyday wear
• Replaces scratched, dented or bent trim that affects appearance
• Helps keep seals and adjacent trim aligned by restoring original fit

• One right-side front trim piece (stainless steel)

• Disconnect power to the appliance before starting any repair
• Remove the door or panels per OEM instructions to access trim fasteners
• Use non-marring tools and a soft cloth to avoid scratching finished surfaces
• Retain all screws and clips; reuse only the fasteners specified by the manufacturer