Parts for Maytag MDG17MNBGW1: 01 - Top And Console Parts

Pilot light not visible or broken lens? This control panel lens cover protects the indicator bulb and diffuses light. Simple snap-in replacement part.

If your dryer won't start or heat, the relay may have failed. This switch controls electrical current to the motor and heating element.

Dryer won't advance through cycles or stops mid-cycle? This timer controls cycle progression and operation duration for multiple dryer models.

Dryer won't advance through cycles or stops mid-cycle? The cycle switch controls the timer progression. Moderate DIY repair, 30-45 minutes.

Dryer won't start when you press the button? This push-to-start switch restores one-press starting. Simple repair that reconnects the motor circuit.

This is a 230-volt indicator lamp used in a clothes dryer to signal when a cycle is running or a specific setting is selected. It mounts on the control panel and illuminates to provide visual feedback during operation. Replace this lamp if the indicator light on your dryer control panel no longer lights up even though the dryer is functioning normally.

Control panel dial for dryers and laundry centers. Replaces cracked, broken, or missing dials. Installs on the control panel to operate cycle settings.

Replace worn, stripped, or missing 8-18 x 3/8 machine screws that secure control panels, trim pieces, and brackets on your appliance. Restores tight fit.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

Small hex nut secures panels, brackets, and components in dryers and laundry centers. Replace worn, missing, or stripped nuts to restore proper fit.

This foam seal cushions and seals the icemaker area to reduce vibration and prevent air leaks that can affect ice quality and efficiency. It's a direct-fit replacement designed to restore proper sealing around the icemaker housing. What it does:

• Cushions the icemaker assembly to reduce noise and movement
• Helps seal gaps to limit warm air intrusion that can cause icemaking issues
• Supports consistent ice production by maintaining the intended airflow path
• Resists compression set for reliable sealing over time

• One foam seal for the icemaker housing

• Basic installation; remove power to the appliance before starting
• Align the seal to the icemaker housing, pressing into place until fully seated
• Inspect surrounding surfaces for debris or damage and clean before installing