Need Help?
Call or text
Show parts
This part is discontinued by the manufacturer and is no longer available for purchase.
Secures dryer wiring to the cabinet to prevent rubbing and interference. Replace if your wire retainer clip is broken, missing, or damaged.
For mating plug use 691707.
Usually ships within 4 - 14 days
For mating terminal use [AP31136300].
Dryer won't power on or trips breaker? This terminal block plug connects power to your dryer's electrical system. Common fix for power issues.
For mating terminal use WP94614.
This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.
Size; 8-18 x 1/2 inch.
This motor connector housing is the molded body that holds the motor's wire terminals for a secure, insulated connection. Replacing a cracked or heat-damaged housing helps restore reliable motor operation and prevent intermittent power issues.
Size: 8-18 x 1/2 inch.
5-circuit wire harness connector for dryers. Connects wiring harness to control board. Replace if cracked, damaged, or pins are bent or corroded.
Color: biscuit. Measures about 2 inches in diameter where the handle extends.
Front load washer control knob. Color: Pewter. For gray order WP8181859. For Biscuit order WP8182049. For blue order WP8181881.
The Washer Control Knob is an OEM replacement part for Whirlpool washers. Causes of malfunctions include stripped interior gears losing secure connection to circuit boards over hundreds of wash cycles. Repeated twisting motions can also cr
Color: Platinum - This is a Whirlpool dryer user interface. It sits behind the outer control panel on top of the dryer and manages and monitors the dryer's cycles. The user interface can short out due to power surge or exposure to excessive heat or moisture. If the dryer is not responding to user input, the control has likely shorted out. Before installing this part, be sure to disconnect power to the appliance and allow it to cool completely. The dryer will need to be pulled away from the wall to access the screws holding the outer control panel in place. Remove the screws from each side of the control panel to gain access to the old control. Disconnect any wire harnesses connected to it and remove any screws mounting it in place before installing the new part. This is a genuine OEM part compatible with dryers manufactured by Whirlpool brands, including Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and others. This product contains no additional parts or hardware.
Color: Pewter