Parts for Whirlpool WED8500BC0: 01 - Top And Console Parts

This is a dryer control board. This component is one of the most important in the dryer since it controls many of the important features of the appliance. For instance, it determines the time and temperature for a cycle of clothes going through the drying process. This part can be damaged over time or through regular use and may need to be replaced.If the control board is malfunctioning, it might cause the dryer to stop heating, alter cycle length, or prevent the appliance from starting at all. Start the process by making sure the dryer is unplugged. A set of tools and work gloves will be useful for the process. Unscrew and remove the top panel before disconnecting the control panel housing. The wires are connected to the control board before disconnecting them. Reattach them to the new component and reassemble the appliance.This is a dryer control board for Whirlpool appliances. It is sold as an authentic OEM replacement part that is sourced directly from the manufacturer. This part is sold on an individual basis.

This electronic control board coordinates the appliance's operations by processing inputs and sending power to critical components. Replacing a failed board can restore reliable performance when the unit won't start, stops mid-cycle, shows error codes, or behaves unpredictably.

• Directs cycle timing and power to motors, valves, heaters, and other loads
• Interprets user interface commands and sensor feedback to run selected programs
• Manages safety checks and built-in diagnostics
• Failure symptoms include: won't start/respond, cycle won't advance, stops mid-cycle, error codes, or intermittent/erratic operation

• Disconnect power at the breaker or unplug the appliance before servicing
• Use ESD precautions and handle the board by the edges
• Transfer any brackets, covers, or jumpers from the original board if required
• Label or photograph wiring, then move one connector at a time to the matching terminals

Screw for control panel.

This self-drilling screw secures appliance panels and components where a fastener must cut its own pilot hole. It provides a quick, reliable hold for repair or reassembly of trim, brackets, and internal fixtures. What it does:

• Fastens panels, brackets, and small components without pre-drilling
• Helps stop loose or rattling trim and parts caused by missing or worn screws
• Restores proper alignment and secure mounting after repairs
• Works where sheet metal or thin substrates require self-tapping engagement

• One self-drilling screw

• Disconnect power and follow appliance safety procedures before starting repairs
• Use the correct size driver and steady pressure to avoid stripping the head
• Start straight and apply firm, even torque; avoid overtightening which can damage mounting surfaces
• Wear eye protection and handle small fasteners carefully to avoid loss or ingestion hazards