Parts for Kitchenaid KBFA20ERWH01: 05 - Unit Parts

Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.

Mounting screw for refrigerators. Secures panels, brackets, or internal components. Replace if stripped, missing, or damaged during appliance repair.

Refrigerator making noise or not cooling? A broken condenser fan blade prevents air circulation. This friction-fit part installs in minutes—no tools needed.

Condensate drain pan collects water under your refrigerator. Replace if cracked, leaking, or damaged to prevent floor water pooling and spillage.

Cushions refrigerator components at mounting points to reduce vibration and rattling. Replace if worn, cracked, or missing to restore quiet operation.

Freezer cold but fridge warm? Frost building on evaporator coils? This defrost heater melts ice buildup to restore proper cooling. DIY-friendly repair.

Refrigerator stopped cooling or compressor won't start? This run capacitor provides the electrical boost needed to start the compressor motor. Easy DIY fix.

Fix a fridge that won't cool but runs—clicking or buzzing sounds point to a failed start relay. This part kickstarts your compressor. DIY-friendly repair.

Replaces worn door gasket edge to restore proper seal and maintain temperature. Install when you notice air leaks or frost buildup. Confirm fit with your model.

Freezer too cold while fridge stays warm? Faulty defrost thermostat prevents proper defrost cycles. Quick clip-in replacement on evaporator coils.

Rubber grommet that cushions and secures the refrigerator condenser assembly. Replace if cracked, worn, or missing to reduce vibration and noise.

Refrigerator not cooling properly? This 36-inch condenser coil removes heat from your fridge. Common fix for warm temps and overheating compressors.

Refrigerator not cooling or running constantly? The evaporator absorbs heat from inside your fridge. This repair requires refrigerator disassembly.

Fix a noisy or non-cooling refrigerator with this condenser fan motor. Solves overheating compressor issues. DIY-friendly repair with video guide.

Drier tube for refrigerators. Installs in the sealed refrigeration system to remove moisture. Replace if cracked, corroded, or during compressor repairs.

Refrigerator won't cool or compressor rattles? This sealed system compressor restores cooling. Professional installation required for refrigerant work.

Fix a condenser fan that won't stay mounted or vibrates excessively with this refrigerator condenser motor bracket. Secures the motor in place.

Replacement mounting screw that secures internal panels, brackets, and components inside your refrigerator. Needed when original fastener is missing or damaged.

Short machine screw that secures refrigerator panels, trim pieces, and brackets. Replace when lost, stripped, or damaged to keep assemblies stable.

Size: 1/2 inch.

Size: 5/8 inch.

Fix refrigerant leaks or low cooling with this 3/4 inch service valve. Essential for AC system pressure testing and refrigerant recharge procedures.

Fix refrigerant leaks or low cooling with this 3/16 inch service valve. Essential for AC recharging and system maintenance on multiple models.

Refrigerator not cooling properly? A faulty 1/4 inch service valve can prevent proper refrigerant flow. This valve connects refrigerant lines in your system.

Service valve for refrigerators, freezers, and ice makers. Used for refrigerant system service and maintenance. 5/16 inch fitting size for technicians.

Fix refrigerant leaks or cooling issues with this 3/8 inch service valve. Essential for refrigeration system repairs and maintenance on multiple models.

Dispenser tube that connects water or ice components in your refrigerator. Replace if cracked, leaking, or broken to restore proper dispenser function.