Parts for Kitchenaid KSBC1B2BM0: Unit Parts

This power cord supplies electrical power to the appliance, replacing a damaged or worn cable to restore reliable power delivery and reduce risk from exposed wiring. Ideal for repairs where the cord is frayed, cut, or not making a secure connection. What it does:

• Delivers mains power from the wall outlet to the appliance so it can operate
• Replaces cords that are damaged, melted, frayed, or show exposed conductors
• Addresses symptoms such as the appliance not powering on, intermittent power loss, or burning/charred odor near the cord
• Restores a secure, insulated connection at the cord inlet and plug

• Disconnect the appliance from power before inspecting or replacing the cord; if hard-wired, switch off breaker and verify no power.
• Route and secure the cord per the appliance's wiring diagram to avoid pinch points or contact with hot surfaces.

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

This factory replacement screw fastens appliance components securely. Use it to replace lost, stripped, or corroded hardware and restore a snug, rattle-free fit and proper alignment of panels and assemblies.

• Secures panels, brackets, and internal components to their mounting points
• Replaces missing or damaged fasteners to maintain correct alignment
• Helps eliminate vibration and rattling caused by loose hardware
• Restores the original fit with OEM-matched threads and dimensions

• Disconnect power and shut off water or gas supplies before servicing
• Use the correct driver bit that matches the screw head to avoid stripping
• Replace one fastener at a time to keep parts aligned
• Tighten snugly; do not overtighten to prevent stripped threads or cracked plastic