Parts for Kitchenaid KSBC2F1BM0: Unit Parts

Blender won't turn on or power button unresponsive? This power switch restores control functions. Simple repair, typically takes 20-30 minutes.

Fix a blender that won't blend or makes grinding noises with this drive coupling. Connects the motor to the blade assembly. Simple repair.

This is the main motor assembly that powers the wash and drain functions inside the dishwasher. It drives the pump to circulate water through the spray arms during the wash cycle and helps drain water at the end of each cycle. Replace this motor if the dishwasher hums without spraying water, fails to drain, makes unusual grinding noises, or does not start the wash cycle at all.

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

This factory replacement screw fastens appliance components securely. Use it to replace lost, stripped, or corroded hardware and restore a snug, rattle-free fit and proper alignment of panels and assemblies.

• Secures panels, brackets, and internal components to their mounting points
• Replaces missing or damaged fasteners to maintain correct alignment
• Helps eliminate vibration and rattling caused by loose hardware
• Restores the original fit with OEM-matched threads and dimensions

• Disconnect power and shut off water or gas supplies before servicing
• Use the correct driver bit that matches the screw head to avoid stripping
• Replace one fastener at a time to keep parts aligned
• Tighten snugly; do not overtighten to prevent stripped threads or cracked plastic