Parts for Kitchenaid KSBC2F1DP0: Unit Parts

This power cord supplies electrical power to the appliance, replacing a damaged or worn cable to restore reliable power delivery and reduce risk from exposed wiring. Ideal for repairs where the cord is frayed, cut, or not making a secure connection. What it does:

• Delivers mains power from the wall outlet to the appliance so it can operate
• Replaces cords that are damaged, melted, frayed, or show exposed conductors
• Addresses symptoms such as the appliance not powering on, intermittent power loss, or burning/charred odor near the cord
• Restores a secure, insulated connection at the cord inlet and plug

• Disconnect the appliance from power before inspecting or replacing the cord; if hard-wired, switch off breaker and verify no power.
• Route and secure the cord per the appliance's wiring diagram to avoid pinch points or contact with hot surfaces.

This drive motor assembly powers the washer's agitation and spin functions to restore normal tub movement and drainage. Replaces a worn or failed motor to help your machine resume proper wash and spin cycles. What it does:

• Rotates the transmission/drum to enable agitation and spin cycles
• Provides torque for draining and high-speed spin to remove water from loads
• Commonly needed when the washer won't agitate, won't spin, or makes grinding/noise from the motor area
• Matches OEM fit and mounting points for a direct replacement when the listed part number is specified

• Disconnect power and water before beginning any repair
• Handle the motor carefully; support the tub/transmission as required to avoid strain
• May require basic hand tools and lifting assistance; refer to the service manual for vehicle-specific steps

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

This factory replacement screw fastens appliance components securely. Use it to replace lost, stripped, or corroded hardware and restore a snug, rattle-free fit and proper alignment of panels and assemblies.

• Secures panels, brackets, and internal components to their mounting points
• Replaces missing or damaged fasteners to maintain correct alignment
• Helps eliminate vibration and rattling caused by loose hardware
• Restores the original fit with OEM-matched threads and dimensions

• Disconnect power and shut off water or gas supplies before servicing
• Use the correct driver bit that matches the screw head to avoid stripping
• Replace one fastener at a time to keep parts aligned
• Tighten snugly; do not overtighten to prevent stripped threads or cracked plastic