Parts for Whirlpool KSB7068CA0: 03 - Unit Parts

This drive motor assembly powers the washer's agitation and spin functions to restore normal tub movement and drainage. Replaces a worn or failed motor to help your machine resume proper wash and spin cycles. What it does:

• Rotates the transmission/drum to enable agitation and spin cycles
• Provides torque for draining and high-speed spin to remove water from loads
• Commonly needed when the washer won't agitate, won't spin, or makes grinding/noise from the motor area
• Matches OEM fit and mounting points for a direct replacement when the listed part number is specified

• Disconnect power and water before beginning any repair
• Handle the motor carefully; support the tub/transmission as required to avoid strain
• May require basic hand tools and lifting assistance; refer to the service manual for vehicle-specific steps

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

This factory replacement screw fastens appliance components securely. Use it to replace lost, stripped, or corroded hardware and restore a snug, rattle-free fit and proper alignment of panels and assemblies.

• Secures panels, brackets, and internal components to their mounting points
• Replaces missing or damaged fasteners to maintain correct alignment
• Helps eliminate vibration and rattling caused by loose hardware
• Restores the original fit with OEM-matched threads and dimensions

• Disconnect power and shut off water or gas supplies before servicing
• Use the correct driver bit that matches the screw head to avoid stripping
• Replace one fastener at a time to keep parts aligned
• Tighten snugly; do not overtighten to prevent stripped threads or cracked plastic