Viking PA020041 Spark Module (0+4) OEM Part

I replaced the existing Tytronics spark module with en exact replacement. These things only seem to last 3 to 5 years on my Viking stove. I learned years ago to buy an exact replacement, not a clone, as otherwise the wiring order may be different. The clones will work, but you may send hours trying different wiring combinations. By using this new exact replacement part I was done with the swap in less than 10 minutes and had my stove working again like new. Tip: A small "screwdriver ratchet" that uses screwdriver bits and a 90 degree ratcheting handle is very helpful to get to some of the screws easily.

Removing the right stove top out of the way,removing guard for spark module and then remove the module itself to be replace.

Purchased replacement spark module. The module is located under the cooktop so had to replace by squeezing under the cabinet to get access. There is a metal plate that covers the module that needed to be removed-four screws. Unplugged the AC to the cooktop and unscrewed the module from the cooktop. Then, one connection at a time, I removed each wired push on connected to new module. After connecting all wires I reattached the module to the cooktop. Amazingly it now works just fine.

Replaced spark module. Just turned off breaker for oven and swapped out the module. It all can be done from the top of the stove. No need to pull out from the wall. Module is inside a small aluminum box. Remove one screw to remove left side burners. Remove two screws to remove aluminum box (these screws also have a ground wire attached) Swapped wires 1:1, removed blue spark module (3 more screws) and re-assembled. Works great, took about 60 minutes. Could probably do it in 30 next time. Easy fix. Plus gave me an opportunity to do some cleanup (which took much longer than the repair).

Replaced the ignitor with the exact factory replacement. Fixed the issue perfectly.