Whirlpool W10155344 Diverter Motor OEM Part

Removed and replaced diverter motor. Ops check good, no more leaking. I'm guessing the seal was the problem but diverter ruined (water residue) from leaking over the last 5 years??? This seal is only available if you buy the tub so followed another review - removed diverter then gently pried out the seal, cleaned and then lubed with silicone grease. Also turned the seal 180 degrees or the opposite way before reinstalling the diverter and then wrapping it all back under the counter.

DIY, changed motor and sump. Put a dab of valve lubricant on seal. Wet outer seal of sump to get it to seat in bottom of tub. Cleaned electrical connectors corroded by leak. Coated connectors with dielectric grease. Had to buy additional clamp. Two clamps came in the sump package but both fit the smaller hose only. Neither fit the large hose. I wish the correct clamps were included. Home improvement store clamp is a little too wide to fit between ridges in large hose.

Replaced diverter motor, reversed o-ring which was improperly installed backwards at factory.

The leak was eliminated by replacing the sump housing and installing a new o-ring on the turbidity sensor.

I watched the video then ordered the part it was there in less than 36 hrs. and installation took less than 30 minutes an absolute prefect match it could not have been any Easier