Charles K Van , TX February 09, 2016 Appliance: Model DU8750XB-1 The access panel broke and needed to be replaced this part is located above the toe panel and just below the door I carefully removed the insulation and metallic trim from the original part using a small knife. I wraped the insulation with Glad Press'n Seal plastic wrap and attached it to the inside of the new part with double sided tape. I attached the metallic trim to the new part with super glue and then attached the Access Panel to the lower front of the dish washer. It took about 30 minutes to do the job but it was not difficult. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Maria D Burlington , MA March 15, 2016 Broken access panel and door panel in poor condition Door panel perfect fit, access panel easy to install looks like when it was new Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Natalie G San Leandro , CA October 25, 2016 The panel was broken Order the part from applinaceParts pros .IT WAS EASY Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Mark J Opelika , AL September 19, 2014 Bottom part of my older diswasher fell off I ordered the replacement part from AppliancePartsPro.I looked on there web site and enter the model and part number that I needed.Then the picture of that part is shown.Then I called there toll free number and ordered the part needed.I had the part in two days. It way easy and simple! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
William U Belleair , FL December 12, 2016 No this part was the correct to fix my problem Use two existing screws Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers