Whirlpool Range / Cooktop / Oven Wire, Harness, Power Cord

Power cord for ranges and ovens. Connects appliance to electrical outlet. Replace if cord is frayed, damaged, or missing for safe operation.

Wire harness for gas cooktops. Connects internal electrical components. Replace if wires are frayed, damaged, or connections are loose or corroded.

This wire harness is a factory-style replacement assembly that restores electrical connections for affected appliance circuits, helping re-establish reliable power and signal routing for safe operation. What it does:

• Replaces damaged or corroded wiring that can cause intermittent power, controls not responding, or component failures
• Restores proper connections between control boards, switches, sensors, and motors where applicable
• Helps eliminate burning smells or visible wire damage linked to failed harnesses
• Provides correct connector fit and wire routing to maintain original appliance function

• One complete wire harness assembly as shown

• Only install if the appliance is unplugged and power is disconnected at the breaker
• Inspect connectors and mating parts for damage before installation; replace any additional damaged components
• Route wires following original paths and secure with existing clips to avoid contact with hot or moving parts

This replacement wire harness restores reliable electrical connections between components, helping your appliance operate safely and consistently. Designed as a direct-fit harness to replace a damaged or faulty wiring assembly. What it does:

• Routes power and signals between control components and functional parts
• Replaces frayed, burned, or broken wires that cause intermittent operation
• Helps stop shorts or open-circuit faults that lead to loss of function
• Maintains factory-style connector fit and wire routing for proper operation

• One replacement wire harness

• Disconnect power at the breaker or unplug appliance before starting
• Verify connector orientation and secure all terminals for proper contact
• Inspect adjacent wiring and strain reliefs; replace or secure if damaged