Whirlpool Range / Cooktop / Oven Burner & Related Parts

Ordered correct replacement parts (your online form helped to identify correct valves 2 had black dot on inside stem for back small burner 1 had red dot for larger front burner). locked stove, turned off gas, unplugged cord. removed knobs, 5 screws and front plate also removed L shaped plate below knobs for better access to comp. fittings. pulled off ignitior controls loosened compression fittings (hard to get wrench on nut but doable), removed screw holding valve to manifold. reversed order... Read more

Ordered correct replacement parts (your online form helped to identify correct valves 2 had black dot on inside stem for back small burner 1 had red dot for larger front burner). locked stove, turned off gas, unplugged cord. removed knobs, 5 screws and front plate also removed L shaped plate below knobs for better access to comp. fittings. pulled off ignitior controls loosened compression fittings (hard to get wrench on nut but doable), removed screw holding valve to manifold. reversed order... Read more

Replace the burner part that was broken. Read more

REPLACED ORIFICES TO BURNERS VERY EASY JOB. Read more

I replaced the old burner with the new burner assembly which included the ignighter. The screw that held the old ignighter was frozen into the old burner such that just the ignighter could not be replaced. Be care full removing the screws to the burner as they also may be frozen and tend to snap off instead of unscrewing. You will need to drill an tap new holes. Read more

We replaced both front orifice holders. Very easy to bend and break. If it has a deep bend in it, It will slow down the gas flow to the burner. if you have a low gas flow your burner will burn low So check your small silver gas lines and if you smell gas check your lines Read more

This fitting is a 3/8 nut driver and an adjustable wrench. Read more

Replaced burners, saved $350, easy and it worked! Read more

We replaced both front orifice holders. Very easy to bend and break. If it has a deep bend in it, It will slow down the gas flow to the burner. if you have a low gas flow your burner will burn low So check your small silver gas lines and if you smell gas check your lines Read more

My Whirlpool stove had two power burners in the front. I don’t need two so I bought the same parts like the back burner. Your website explained that I need the burner valve also. My son changed it out with no problem. I received my order in one day! We watched the video so we were prepared. I recommend this website to anyone. Read more

Ordered caps and self installed. Read more

Ordered a new burner cap. Read more

Replaced igniter under oven floor panel. Read more

I purchased a burner and a oven orifice replacement kit from Appliance Parts Pros. I downloaded an installation manual from Whirlpool and followed the instructions. It was pretty easy. The front burner orifices could be replaced by just taking off the burner cover. The back ones required removing the burner diffuser. You will need to reattach the back burner bottom assembies after you remove the diffuser before you unscrew the orifice or it might bend the burner piping causing it to not line up... Read more

Changing out the stovetop orifices from natural gas to propane- First thing, turn off the gas. On this model stove, there are five burners-two burners in the front, two in the back and one in the middle. The front two burners are different than the other three, they are the largest burners. You can use a 11/32 socket with an extension to go down the middle hole of the burner and screw-out the natural gas orifices. Taking the orifices out was easy. Putting the new orifices in is a different... Read more