Whirlpool Range Hood Damper & Related

This hood damper is the backdraft flap in the exhaust outlet. It opens when the blower runs to vent air outside and closes when off to help block outside drafts, odors, and pests from entering.

• Controls airflow from the blower to the duct during ventilation
• Closes when off to reduce backdrafts and outside air intrusion
• Helps maintain effective capture of smoke, steam, and odors
• Typical symptoms: drafts through the vent, flapping/rattling noises, poor venting, or a broken/missing flap

• Disconnect power; if vented, support or disconnect ducting as needed
• Access the exhaust outlet and remove the damaged damper
• Install with arrow/hinge oriented for airflow; the flap moves freely without binding
• Reassemble ductwork, restore power, and test the fan on all speeds

A duct kit designed to route a dryer's exhaust safely to the household vent system, restoring proper airflow and helping the dryer vent effectively when the original ducting is damaged or missing. What it does:

• Channels hot, lint-laden exhaust from the dryer to the exterior vent to reduce indoor heat and moisture.
• Replaces crushed, torn or disconnected ducting that can cause poor drying performance.
• Use when you notice longer dry times, excess heat or lint buildup near the dryer, or backdrafting from the vent.
• Helps maintain proper vent airflow when installed and secured per manufacturer and local code requirements.

• Disconnect electrical power (and gas supply for gas dryers) before installing or servicing venting components.
• Follow the appliance manufacturer's installation instructions and local building/venting codes for diameter, length and material.
• Avoid crushing, kinking or sharp bends in the duct; secure joints with approved clamps or foil tape and check for leaks.

This duct kit provides the exhaust connection needed to route appliance airflow to a home vent, helping maintain proper venting and reduce moisture and lint buildup for safer, more efficient operation. What it does

• Connects the appliance exhaust outlet to the home vent, creating a secure airflow path
• Helps restore proper airflow that can reduce long drying times or poor ventilation
• Minimizes gaps where lint and moisture can escape into the cabinet or room
• Works with standard rigid or flexible venting to complete a proper exhaust run

• Always disconnect power (and gas, if applicable) before accessing or servicing the appliance.
• Follow all local venting codes and the appliance manufacturer's installation instructions.
• Ensure all connections are tight and supported; avoid crushing or sharp bends that restrict airflow.
• Use appropriate clamps or fastening hardware and inspect for leaks after installation.

This air duct channels internal airflow to help the appliance operate efficiently and prevent air leaks. It replaces a damaged or cracked duct so the unit can move air where it's needed for normal performance. What it does

• Directs air between the blower and internal compartments to maintain proper airflow
• Helps prevent air leaks that can reduce performance or extend cycle times
• Keeps heated or cooled air inside the intended air path for efficient operation
• A cracked or broken duct can cause noisy airflow, poor performance, or uneven results

• One air duct

• Disconnect power (and water, if applicable) before starting any repair
• Inspect adjoining seals and mounting tabs; replace if damaged for a proper fit
• May require basic hand tools to remove panels and fasteners; follow OEM service instructions