Whirlpool Range Hood Support Parts

A replacement mounting plate that secures internal components and restores proper alignment in compatible Whirlpool appliances. Helps stop rattling and loose parts so the appliance runs more quietly and reliably. What it does:

• Secures and supports internal assemblies to maintain correct positioning
• Prevents vibration and rattling caused by a damaged or bent plate
• Helps maintain proper clearance so moving parts operate without interference
• Restores stable fit when the original plate is cracked, warped, or corroded

• Disconnect power (unplug or shut off breaker) before starting any repair
• Remove the appropriate access panel or trim to reach the plate; keep track of fasteners
• Use basic hand tools; avoid over-tightening screws to prevent distortion

This light support is the small mounting bracket that holds an appliance light assembly securely in place, ensuring proper alignment and stable positioning so the oven or appliance light stays put and functions correctly. What it does:

• Secures the interior light assembly or socket to the appliance frame
• Keeps the bulb and lens aligned so the light illuminates the cavity evenly
• Prevents the light or lens from rattling or shifting during use
• Helps maintain electrical contact by stabilizing the socket area

• One light support mounting bracket

• Disconnect power or unplug the appliance before starting any work
• Handle bulbs and lenses carefully to avoid breakage; wear gloves and eye protection
• Typically installs with 1–2 screws; use the same screw locations shown in the appliance's parts diagram
• Inspect and replace damaged light assembly or socket as needed

This light support is the mounting bracket that holds the interior light assembly in place so the lamp stays secure and aligned for reliable illumination. Fits as the replacement bracket used with the factory light assembly. What it does:

• Secures the refrigerator/freezer interior light housing to prevent sagging or misalignment
• Restores proper positioning so the bulb and lens illuminate the compartment correctly
• Stops rattling or movement caused by a cracked or worn support
• Helps ensure light switches or sockets engage properly when the door opens/closes

• Disconnect power to the appliance before starting any repair
• Handle bulbs and lenses carefully to avoid breakage; remove bulb if needed for access
• Typically requires basic hand tools (screwdriver); keep fasteners for reuse unless damaged

This back support is a replacement rear cabinet support that helps secure and stabilize the appliance's rear panel and internal components for safe, reliable operation. It restores proper alignment and reduces rattling or sagging at the back. What it does

• Reinforces the appliance rear cabinet to maintain panel alignment and structural stability.
• Helps reduce back-panel vibration, rattling or sagging that can occur with worn or damaged supports.
• Provides a secure mounting point for internal parts attached to the rear of the cabinet.
• Compatible when the original rear support is cracked, bent, or missing.

• One back support

• Basic hand tools required; follow manufacturer service instructions for disassembly and reassembly.
• Disconnect power (and water, if applicable) before starting any repair.
• Inspect adjacent fasteners and mounting points; replace any stripped or damaged hardware.