Whirlpool Refrigerator Drawer, Shelf, Pan

This Support is a replacement mounting bracket that stabilizes and secures appliance components for reliable operation. Restores proper fit and helps prevent movement or misalignment that can cause noise or part wear. What it does:

• Provides a secure mounting point for associated panels or components
• Helps keep moving parts aligned to reduce rubbing, vibration, or rattling
• Restores original fit when a worn or broken support causes looseness
• Suitable when a damaged bracket is visible or when parts shift out of place

• One Support

• Basic hand tools required; disconnect power and water before starting
• Inspect surrounding fasteners and replace any that are stripped or damaged
• Tighten to OEM torque if specified in manufacturer instructions; avoid over-tightening

This support holds and stabilizes an appliance component to keep parts aligned and reduce vibration for reliable operation. It's a simple replacement that restores proper fit and function where a worn or broken support causes issues. What it does:

• Secures and aligns adjacent components or assemblies to prevent shifting during use
• Stabilizes moving parts to reduce vibration, noise, and rubbing
• Helps maintain sealing and clearance to avoid wear or interference
• Commonly replaced when cracked, broken, or missing and causing rattling, misalignment, or instability

• One support as shown

• Inspect surrounding clips and fasteners; replace any that are damaged
• Use correct screws or hardware and tighten to OEM torque where specified
• Disconnect power and follow safety guidelines before working on the appliance

This rail secures and guides the washer lid, restoring proper lid alignment and smooth opening/closing. Replaces a worn, cracked, or loose lid rail to reduce rattling and prevent the lid from catching during use. What it does:

• Provides a stable mounting surface for the washer lid so it opens and closes evenly
• Guides lid movement and helps prevent misalignment or binding
• Reduces noise and rattling caused by a loose or damaged rail
• Helps keep the lid seated correctly to prevent accidental gaps or snags

• Typical install requires removing the top or accessing the lid hinge area; retain original fasteners unless replacements are provided
• Disconnect power to the appliance before starting work to avoid injury

Right hand side

Left hand side

Right hand side

This for the left hand side

This track is the roller support that guides a sliding assembly for proper alignment and smooth movement, helping restore stable, quieter operation. It's a direct-fit replacement when the original track is worn, bent, or damaged. What it does:

• Guides rollers or glides so doors/drawers/drums move smoothly along their path
• Keeps the sliding assembly aligned to prevent sticking, wobbling, or binding
• Reduces noise caused by uneven or damaged tracks
• Restores proper movement after wear, corrosion, or physical damage

• Disconnect power (and water if applicable) before starting any repair
• Basic hand tools typically required; support the assembly to prevent drops
• Inspect associated rollers, clips, and fasteners and replace if worn
• Test the unit after installation to ensure smooth, quiet operation

This slide is the replacement guide that lets an oven or warming drawer open and close smoothly, restoring proper support and alignment for the drawer. Durable, low-profile fit that helps reduce sticking and uneven movement. What it does:

• Guides and supports the oven/warmer drawer during use for smooth sliding action
• Helps prevent the drawer from binding, catching, or coming off the track
• Reduces noise and uneven movement caused by worn or damaged guides
• Restores correct alignment so the drawer closes flush and operates reliably

• Disconnect power to the appliance before beginning any repair
• Remove the drawer per the appliance service instructions to access the existing slide
• Compare the new slide to the old part for proper orientation before installing
• Tighten fasteners securely and test drawer operation; do not force components