Whirlpool W10135004 Washer Suspension Spring Kit OEM Part

Ordered the springs and shocks. Noticed that the washer had placement for 4 springs, but the factory only installs 2 (or they forgot to install the other two on my machine). If you replace the springs, be sure to check for the spring bracket mount. You will also need those. The washer is running fine. Next I'll work on the dryer.

Installed 2 springs and 4 shocks. Have only used one time since repair, shaking is a lot better.

Tub bearing failure, basically the whole machine has to be taken a part. I've used appliancepartspros in the past so I came back. Quick shipping, parts ordered Thursday night and got here Monday. Take your time or you'll just cost yourself more money. I was lucky in that I did not have to buy the $568 inner tub because I found a bearing and seal kit on Amazon for $80. Historically appliancepartspros' website has been very accurate indicating in stock or not. It appears those days are gone. I would buy here again, but I will never own another front load washer.

Replaced the 2 suspension springs and 4 shocks - your videos made it easy enough that anyone able to grasp a tool could accomplish the same repair. Nice trick with the rope to remove and replace the springs - even showed my kids and had them replace the springs.

Replaced all 4 shocks and both springs. It should be noted that on a HE4 machine you can do all of this by removing the top cover panel and the front lower panel. You can reach all for shocks, use channel locks to twist off, and you can support the tub with block this way while replacing the springs from the top. Other alteration that I would recommend for replacing the springs is to actually use rope or strong wire to tie up the tub if you don't have really heavy duty zip ties. The sharp edge on the washer metal will cut through smaller zip ties.