Whirlpool WP35001191 Thermistor OEM Part

Replaced heating element about three months ago. Had to order thermistor because of error code "ts" on display and dryer would not run. Removed the two screws on the back that holds the top in place. After removing the top, remove the screws that hold the control panel on front. Make sure not to break the tabs that help hold it in place You do not have to unplug any connectors for the control panel. Lay control panel across top of dryer carefully so that it will be out of the way. Next remove the screws that hold the front panel in place. You will see them after removing the control panel. Once these screws are removed, the control panel will lean outward but will not fall. You will have to unplug the sensor for the door lock. Once this is unplugged, pick up on the front panel to remove it off the hinges on the bottom of the front panel. You will now see the panel that covers the blower fan. Remove the three screws and remove this panel. If there is lint built up in this section, you will need to remove it (vacuum cleaner works good). To the right side of this section, there is a plastic tube that sends the lint out the back of the dryer vent. In the elbow of this plastic tube is the thermistor. It has a electrical connect and is held in place by two screws. Carefully unplug the connector and remove the two screws. Replace with new thermistor by attaching with the two screws and reconnect the electrical connector. Reattached the front plate with the three screws over the blower fan. (Make sure lint has been removed so air flow will not be restricted. Reattach front panel by positioning panel on lower hinges and reattach the electrical connector for door lock. Secure front panel with screws across top of panel. Reattach control panel by replacing screws across the top holes of control panel. Reinstall top panel and replacing the two screws in the back. Turn on power. Reset code "ts" on display by going into service mode. Press the Chime and Temperature keys for about 3 seconds or until you hear 3 beeps. Access the diagnostic codes by pressing the wrinkle prevent key. A "D" will be displayed. Press sensor dry and time keys for about 3 seconds to clear the code. Power off dryer to exit the service mode. Power on the dryer. Should be no error code.

I had to replace the thermistor and the thermostat. They are located under the front panel of the dryer. Once I entered service mode and cleared the error code, the dryer worked. To enter service mode, turn on the dryer and hold down the chime and temperature buttons simultaneously for 3 seconds. From there, press the wrinkle prevent button and you will see a d. Hold the sensor dry level and time buttons for 3 seconds to clear the t5 error code. Turn the dryer off and then on again. Start your dryer cycle.

I checked the thermostat and thermistor. Both were bad with no continuity, replaced both and until now with no problem.

Changed Thermistor, Thermostats and the Thermal Fuse Assembly. I did not remove drum, so squeezing my hands in-between drum and vent hose pipe to remove screws was a tight fit, but doable.

I had to take apart the dryer panels to access the inside bottom front of the dryer to get to the thermistor. So I googled appliance parts dealers and came across appliance parts pros. They had the cheapest price including shipping compared to all others. I ordered the part at 1pm on Monday and had it by 4pm Tuesday and was able to replace the part and have my dryer back up and working properly that night.