Todd B Dummerston , VT August 14, 2016 Dryer would run but wouldn't heat I replaced the thermal cut-off sensors and the cutoff-Tml Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Edward B Ellisville , MO May 08, 2015 Appliance: Model WHIRLPOOL LTE6234002 No heat The Cutoff-TML fixed it but of greater issue is how fast AppliancePartsPros get the parts to you. The part was here the next day after it shipped. I depend on APP because of this service. They understand the business and customer needs...unlike so many other service organizations. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
M H Frisco , CO July 18, 2014 In the "detect dry" mode it didn't heat heated fine in the timed mode turned in both modes Replaced this fuse, which controlled the temperature detection for the detect-dryness mode. The way that mode works is that when the clothes are dry, they no longer have enough moisture to decrease the dryer temperature. So the circuit controlled by this fuse detects the increase in temp & turns the dryer off. Once the fuse blew (I'm not sure why), that circuit perceived the temp as too high & kept the heat off. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Screwdrivers, Socket Set
Andrew P North Highlands , CA September 22, 2020 Appliance: Kenmore Stackable Washer Dryer 11092962102 Dryer would not heat up I did kind of use the shotgun method in this repair. I replaced all four of the internal sensors and the moisture bar. I figured with all new sensors, another one of the old ones may have failed in the future and I would be back into it again. I did check the heating coil with my ohm meter and it was fine. This unit is 17.5 years old, it is a Sears Elite Series and I was told worth repairing. It is a combo washer/dryer, so the videos here dont show the proper location of the parts, but they are the same and it takes just a few minutes to orient yourself to finding them all. $175 in parts and it was up and running again and working perfect. I recommend taking pictures before you begin for reference later. The pictures help with the older memory! FEDX was very slow in the parts delivery, so be prepared for that. I also did a lot of cleaning of lint from everywhere in this unit, it is a good thing to do while you have it all apart. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers, Socket Set
Deborah R Fulton , TX July 16, 2018 Needed to replace thermal limiter due to dryer not heating I replaced the part your company sent. The dryer is now heating and drying my clothes! Yea! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Wrench Set