Whirlpool Wall Oven Trim

This left-hand side trim finishes and protects the edge of the appliance's panel or housing, restoring a clean, factory look. Replace when the original trim is cracked, missing, or loose to keep panels aligned and edges covered.

• Provides a finished edge on the left side and improves overall appearance
• Helps cover gaps and protect edges from snags or chipping
• Aids proper alignment of adjacent panels or consoles
• Replace if cracked, warped, loose, or missing
• Common symptoms: visible gap on the left side, rattling/loose panel, sharp or broken edge, cosmetic damage

• Disconnect power before servicing; also shut off gas supply
• Wear cut-resistant gloves; edges and surrounding panels can be sharp
• Left/right orientation is determined when facing the front of the appliance
• Align the trim and secure with existing hardware; do not overtighten fasteners

This vent control damper assembly opens and closes the appliance vent to allow steam and exhaust to exit when needed, helping maintain proper airflow and reduce moisture buildup. It replaces a worn or stuck vent actuator. What it does:

• Operates the vent/damper to allow exhaust air to escape during use
• Prevents vent from staying stuck open or closed, which can cause excess moisture or reduced airflow
• Restores proper venting function when the original damper fails or binds
• Works as the mechanical control between the appliance cavity and external venting path

• One vent control (damper) assembly

• Disconnect power to the appliance before beginning any service
• Access may require removing exterior panels or the back cover
• Handle the damper gently to avoid bending the flap or linkages

The side trim is a finishing piece that covers the appliance's right edge. Replacing a damaged or missing trim restores the factory look and helps keep adjacent panels aligned for proper fit.

• Finishes and protects the right-side edge of the unit for a clean appearance
• Helps align and secure adjoining panels or console components
• Reduces unsightly gaps that can collect debris
• Common symptoms: cracked, chipped, warped, loose, or missing trim; rattling or poor panel alignment

• Disconnect power to the appliance before service; allow hot surfaces to cool
• Wear cut-resistant gloves—edges and surrounding panels can be sharp
• Note right-hand orientation; transfer any clips/brackets from the old trim if present
• Align tabs and fasteners carefully; tighten hardware just snug to avoid distortion

This oven vent directs hot air out of the oven cavity and helps maintain proper internal temperature and airflow. It replaces a damaged or warped vent to restore venting performance and oven appearance. What it does:

• Channels heat and steam out of the oven cavity to support even cooking
• Helps prevent heat buildup behind the oven and adjacent cabinetry
• Replaces cracked, bent or discolored vent trim that can affect airflow or appearance
• Compatible with factory vent locations — installs where the original vent was mounted

• Designed for rear/top vent mounting; verify orientation matches your appliance before installing
• Disconnect power to the appliance before beginning any service to avoid shock or injury
• Handle edges carefully; use appropriate tools to remove mounting screws and clips
• If vent damage is extensive or other components are affected, inspect surrounding parts and wiring

Right hand side. For the left side order 814374.

Color: Black

This is the right side, side rail. For left side use 814372.

Color: Black

Color: Biscuit.

Color: Black. This is the left side, side trim. For right side use 4452624.

Color: White. This is the right side, side trim. For left side use 4452627.