Yard Machines Filter

This is an oil filter designed to fit a variety of small, gasoline-powered motors used primarily on lawn equipment. This genuine OEM replacement filter removes contaminants that otherwise would wear down the internal working parts of the engine. While the filter works very well, it should be replaced annually as a part of regular maintenance. Depending on use, the filter may need to be replaced more often. When replacing the oil filter, the crankcase oil must be drained and safely discarded as well. To remove oil from the gasoline engine, start the engine and let it run for a couple of minutes. This circulates the oil and heats the internal engine parts so oil is better able to drain. Next, remove the drain plug located on the bottom of the oil pan and collect the oil. Remember to dispose of the oil safely where it cannot contaminate streams or aquifers. Once the oil has been removed, remove the old filter and discard it properly. The new filter should only be hand-tightened in place as using a wrench may cause the filter gasket to seal to the engine block. This filter will fit Yard Machine mower engines and MTD equipment.

Installing a brand-new air filter keeps the engine in top running condition. When the machine is in operation, the vacuumed air goes through the air filter. Any dirt or dust is left in the filter media. Over time, the filter will become dirty and can no longer provide the same filtering efficiency as before. If left ignored, the tiny particles could clog the engine and the carburetor. You may experience misfires and no engine start-up. An air filter replacement is cheap and easy to do. Simply remove the air cleaner cover and take out the dirty filter. Insert the new filter into the housing. This replacement will take less than 5 minutes. A screwdriver will be needed. The MTD 951-10298 Air Cleaner Kit is a genuine air filter from MTD. Each kit comes with one paper filter and one foam filter. The foam filter can be cleaned with water and detergent. The paper filter, however, needs replacement at least once a year. This air filter kit is compatible with Cub Cadet, PowerMore, and Troy-Bilt. It can also work with other garden equipment like wheel string trimmers, chipper-shredder vacuums, and log splitters.

This is an air cleaner housing that works with many types of lawn and garden equipment. The housing fits over the air filter, which is the component that prevents dirt and debris from reaching the engine where it can cause performance issues. The housing sits on top of the filter and keeps it protected from damage. It also plays a part in ensuring that dust and dirt aren't sent out into the air.Wear and tear can cause the air filter housing to break or become damaged. Impact to the air cleaner housing can also lead to cracks, holes, or a weakened housing that will need to be replaced. The replacement process will require a pair of work gloves and a screwdriver. The air cleaner housing will attach through screws so remove those first. Take off the old housing and install the new one by screwing it on.This air cleaner housing is an authentic OEM replacement part directly sourced from the manufacturer. It is sold individually. The air cleaner housing is compatible with lawnmowers, log splitters, edgers, tillers, string trimmers, and chipper shredders created by Yard Man, Cub Cadet, Craftsman, and MTD.

This replacement foam air filter is an authentic OEM replacement part for both lawn tillers and cultivators. For a combustion engine to run effectively, the carburetor must maintain a balance of fuel and air. Therefore, the engine takes in air from the outside and mixes it with fuel. However, if the air is dusty, it will clog the carburetor and cause the engine to seize up. To prevent this from happening, manufacturers add an air filter like this one to capture any dust or debris. When lawn appliances are in use, they often kick a lot of dirt into the air. This means that air filters get a lot of use every time an operator uses their appliance. Eventually, the filter will reach max capacity, and air will no longer pass through it. When this happens, the filter will need replacing. Changing out an air filter is a simple job and will only require a screwdriver at most. This part is made for Cub Cadet, Troy-Bilt, and MTD tillers and cultivators and is sourced from its original manufacturer. This part ships individually.

This replacement part air cleaner is an OEM part for use in small engines used in outdoor equipment, such as tillers and dethatchers. The air cleaner is responsible for ensuring that clean air is brought into the engine to provide optimal performance. It is a good idea to inspect the air cleaner assembly regularly to ensure that there is no damage or cracks that could allow dirt and debris to get into the engine. If there are any issues, get a replacement before operating the engine again. This will ensure that there is no additional dirt getting into the engine. The genuine OEM air cleaner is a quality item that comes from the manufacturer. It is sold individually. It can work with tillers and other machines from top brands like MTD, Craftsman, and Yard Machines.

This is a sponge filter that is used in several types of lawn and garden equipment. It helps remove dirt, dust, and other debris before it can reach the engine. If the sponge filter is dirty, damaged, or otherwise not working correctly, debris can end up clogging the carburetor, which will weaken performance or prevent it from starting completely. If the dust and dirt reach the engine, serious engine damage can occur.Inspecting the sponge filter on a regular basis is important to ensure it's working well. It also needs to be replaced at least annually, and possibly more often depending on wear and tear. Replacing the air filter is simple. Take off the lid on the filter and then remove it from the machine. Replace it with the new sponge filter and replace the lid.This is a genuine OEM replacement part that is directly sourced from the manufacturer. It is sold as an individual part. The sponge filter is compatible with lawnmowers, lawn tractors, and wood chippers manufactured by Craftsman, Huskee, Cub Cadet, MTD, and Yard Machines.

Mowers are manufactured to last for about 500 hours of running, which breaks down to about 19-20 years for the typical non-commercial user. Commercial mowers, which see a great deal more use, are designed to last for 1000 hours of service, which is about 10 years. To extend the life of a lawn mower to its full potential, there are certain simple preventative routines a user can follow, including annual oil and filter changes. One important routine maintenance ritual for mowers that is often overlooked is changing the air filter, something that should be done at least annually. When the mower chugs, cycles, or simply will not start, the first thing to check is the air filter. When replacing the filter, make sure to use a genuine OEM certified replacement part like this one, which is manufactured according to the specification of the original factory filter. This filter is compatible with Bolens, Yard-Man, Troy-Bilt, Yard Machines, and MTD.

This brand-new, original MTD air filter attaches inside the air filter housing of a string trimmer to block debris and dirt. Tiny particles can accumulate inside the machine and cause carburetor and engine problems. String trimmers come with pre-installed air filters, but when it becomes too dirty, it will not be able to filter the tiny particles efficiently. It may also cause overheating issues. When there's too much dirt accumulation inside the string trimmer, it may disrupt the carburetor and engine performance. Some symptoms include carburetor and engine spit back and rough idling. In some scenarios, it will lead to complete machine failure. Replacing the air filter is easy, only requires a screwdriver, and will take less than 10 minutes. Open the air filter cover and remove the dirty filter. Put the replacement filter into the air cleaner housing. Make sure it is aligned. Then, close the air cleaner cover. This genuine MTD air filter will only work with string trimmer models from MTD, Bolens, Yard Machines, Craftsman, and Cub Cadet. This air filter is sold individually.

As an air filter for trimmers used in the yard, this component helps keep the engine running smoothly when doing work. A clean air filter supplies the engine with clean air for the best performance. A visual inspection of the filter will offer insight into whether a replacement is needed. Maintaining the air filter will ensure it lasts longer and keeps debris from clogging the carburetor of the trimmer. If the original air filter has obstructions or large amounts of debris, it’s best to replace it. Tears in the filter also indicate a replacement is required to prevent any damage to the engine. This will entail removing the old air filter and placing a new one where it was. Opening the engine cover will give you access to the area where the air filter is housed. This replacement air filter is an OEM product that is directly from the manufacturer. It comes as an individual item and is designed for use with various Craftsman, Yard-Man, Cub Cadet, Bolens, Troy-Bilt, MTD, Murray, and Yard Machines trimmers. A screwdriver may be required to install the new air filter into the equipment.

This air filter replacement is designed for use with MTD line trimmers. It filters the air that comes into the engine to remove debris, particles, and various fuel and oil residues to ensure only the cleanest air gets through to the carburetor. Because of its job, the air filter will naturally become clogged over time with regular use, but many people also keep an additional filter on hand for emergency or intermittent replacements. The air filter should be replaced annually as a part of routine maintenance, or whenever it becomes clogged. This genuine OEM filter is manufactured to exact specifications by MTD and is compatible with Troy-Bilt and Cub Cadet trimmers. Be sure the engine is cool before beginning any repairs and wear gloves for hand protection. No tools are required for this part replacement, which can be done in just a few minutes. This filter is sold individually and those who need more than one will have to order multiple quantities.

The air filter sifts out particles and debris as air enters the engine of the mower. In small equipment engines, air filters can help provide optimal performance of the engine. The filter is made of durable foam and is rectangular in shape and is sold as a single unit. Over time, they can become clogged with debris and particles and may require replacement as a part of regular maintenance. This MTD air filter replacement will keep equipment running better and releasing fewer emissions. Before installing, soak the filter in oil and then remove the excess. The oil will help catch more debris than a dry filter would and provide more protection for the engine. This filter is made to exact OEM standards and is designed for use on select gas-powered blowers and trimmers made by MTD, Troy-Bilt, and Cub Cadet.

This part is a replacement air cleaner cover assembly. This is a genuine OEM part made by MTD and has been sourced directly from the manufacturer. This part can be used to replace a broken or defective air cleaner cover assembly in a variety of trimmer models. This air cleaner cover assembly protects the air filter from becoming damaged. If the air filter is not secured by the cover, it could lead to dirt and debris entering the internal engine components. For this reason, the air cleaner cover should be replaced if cracked or damaged in any way. It's important when working on or near any engine to make sure the equipment is powered off and completely cooled down before starting any repairs. No special tools are required to replace this part, simply snap into place. For more accurate information on how and where to install this air cleaner cover assembly, the appropriate owner's manual and equipment diagrams should be referred to. As an authentic replacement part, this air cleaner cover assembly is suitable for use on several different models of trimmers manufactured by MTD, Troy-Bilt, Cub Cadet, and Yard Machines. This is a genuine part made of high-quality, durable plastic and is sold individually.