Yard-Man Parts

This part is a replacement air cleaner assembly. This is a genuine OEM part made by MTD and has been sourced directly from the manufacturer. This part is intended for use as a replacement for a broken, worn, or defective air cleaner assembly on various models of blowers. This air cleaner assembly includes the base, cover, and the foam air filter itself. This part helps to make sure that dirt, debris, and contaminants are filtered out of the air as it enters the engine so it doesn't have a negative effect on the equipment. Air filters should be cleaned regularly and replaced when worn or old. Wear work gloves to protect the hands and check that equipment is powered off and cooled down before starting the repair process. For more accurate information on how and where to install this air filter assembly, the appropriate owner's manual and equipment diagrams should be referenced. This air filter assembly is a genuine OEM part made of durable materials and is sold individually. It is suitable for use with blower models that have been manufactured by MTD and Craftsman.

This electronic component generates the spark needed to ignite the fuel mixture in the leaf blower's engine, typically mounted near the spark plug. Replace when the engine fails to start, runs roughly, or stalls frequently despite proper fuel and air flow.

This impeller can be used as a replacement part for the small engine of a leaf blower or a leaf vacuum. The function of an impeller, which operates by rotation, is to take in the leaves and eject them out of the chute.An impeller might have to be replaced if it suffers damage that impedes it from properly ejecting the leaves from the chute. A common symptom of an impeller that needs to be replaced is that the leaves are not ejected with enough force from the chute or that the ejection process stalls or does not occur at all. If this is the case, the impeller should be removed and replaced with this genuine OEM replacement part immediately before using the leaf blower or leaf vacuum again. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This is an OEM part sourced directly from the manufacturer, MTD, and it is sold individually. This impeller is compatible with the following brands: MTD, Troy-Bilt, and Yard Man.

Starter rope pulls freely without engaging? This pawl assembly restores proper starter engagement with the flywheel on gas leaf blowers and trimmers.

Blade guard assembly for line trimmers. Protects operator from debris and rotating components. Replace if cracked, broken, or missing for safe operation.

Rubber spiral auger kit for snow blowers. Replace when rubber paddles are worn, cracked, or no longer effectively move snow. Confirm fit with your model.

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

Throttle cable for gas line trimmers. Connects carburetor to throttle trigger. Replace if damaged, kinked, frayed, or broken during use.

Skid shoe kit for snow throwers. Mounts to the base housing to protect the auger from ground contact. Replace if worn, cracked, or missing.

Flywheel assembly for gas leaf blowers and line trimmers. Mounts to the engine crankshaft. Replace if cracked, damaged, or missing flywheel fins.

Ignition module for gas leaf blowers and line trimmers. Mounts to the engine to control spark timing. Replace if cracked, damaged, or missing.

String trimmer won't cut or head doesn't spin? Likely stripped gears in the gearbox. This assembly drives the cutting head. DIY install in minutes.