Parts for Admiral GS2127CAHB: 02 - Controls Parts

This damper assembly controls airflow between the fresh food and freezer compartments in your refrigerator. It regulates temperature by opening and closing to maintain proper cooling in each section. Replace it if one compartment is too warm or cold, or if you hear unusual noises when the refrigerator cycles.

Fixes loose panels, rattling doors, or wobbly components caused by stripped or missing screws. Secures brackets, covers, and mounting hardware. Easy DIY.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

This damper assembly controls airflow between the fresh food and freezer compartments in your refrigerator. It regulates temperature by opening and closing to maintain proper cooling in each section. Replace it if one compartment is too warm or cold, or if you hear unusual noises when the refrigerator cycles.

Freezer icing up or not defrosting? A faulty defrost timer prevents the automatic defrost cycle. This rotary timer restores proper defrost timing.

This is a flexible rubber seal that attaches around the perimeter of the refrigerator door. It creates an airtight seal when the door is closed to maintain proper internal temperature and prevent warm air from entering. Replace this gasket if you notice condensation forming around the door edges, the refrigerator running constantly, or if the seal is torn, cracked, or no longer holding the door closed tightly.

Refrigerator light won't turn off or on? The door switch detects when the door opens and closes. Easy 5-minute DIY repair with a pick tool or scraper.

Replacement mounting screw for refrigerator interior components and panels. Needed when original screws are stripped, lost, or damaged during repair.

This control wire harness connects the appliance control board to sensors, switches and powered components to restore electrical communication and proper function. It replaces a damaged or loose harness to help resolve intermittent or non-responsive controls. What it does:

• Carries power and low-voltage control signals between the main control board and components.
• Restores operation when frayed, burned, or cracked wiring causes intermittent circuits or loss of specific functions.
• Helps stop faults caused by broken connector tabs, corroded terminals, or detached plugs.
• Resolves error codes or unresponsive buttons that trace back to wiring faults.

• Disconnect power (unplug or switch off breaker) before starting; shock hazard exists.
• Compare the new harness to the original for connector type and routing before installing.
• Route and secure the harness exactly as the original using existing clips/retainers to avoid pinching or heat exposure.