Parts for Maytag LSG7804ABL: 11 - Top & Lid Parts

This PC switch senses the washer lid position and tells the control when the lid is open or closed so the washer operates safely. It replaces a worn or failed lid position sensor to restore normal cycle starts and door-safety behavior. What it does:

• Detects lid open/closed status and signals the control board
• Prevents washer from starting or spinning when lid is open
• Can correct symptoms like no-start, no-spin, or interrupted cycles when the lid is closed
• Works as the user-accessible lid position safety switch used by the control

• One PC switch

• Disconnect power before beginning any service to avoid shock or injury
• Access may require removing the washer top or control console
• Observe wiring orientation and connector placement; transfer connectors exactly or label before removal
• Test operation after install and reassemble panels securely

Note: When more than one switch is listed, check the first 2 digits of the serial number for the correct item number.

This lid bumper cushions the contact point between a washer lid and the top panel to reduce slamming noise and protect the finish. Replacing a worn or missing bumper restores smooth, quiet lid operation and helps prevent paint damage.

• Provides a soft stop between the lid and top to minimize noise and vibration
• Helps prevent chips, scratches, and rust where the lid meets the cabinet
• Maintains proper lid spacing for a solid, rattle-free close
• Common signs it's needed: missing/flattened bumper, louder closing, rattling, or visible wear at contact points

• Disconnect power before servicing
• Open the lid, remove the old bumper, and clean the mounting area
• Seat the new bumper fully in the mounting location as designed
• Open/close the lid to ensure quiet, secure contact

The Lid Check Switch is an OEM part for Whirlpool washing machines. It ensures the washer operates only when the lid is securely closed, providing a safety mechanism to prevent the machine from running with the lid open. This is the switch only. For the complete assembly including the switch order part number AP6006235.

Causes of a bad lid check switch can include wear and tear over time, damage from repeated use, or issues with the electrical connections. If the switch fails, it can prevent the washer from starting or interrupt the wash cycle.

Symptoms of a bad lid check switch include:

• Washer not starting
• Interruption of the wash cycle
• Error codes indicating lid issues
• Lid not locking properly

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.