Parts for Speed Queen ADE3SRGS173TW01: Access Panel / Front Panel / Seal Parts

A replacement self-tapping pan-head screw sized 10 x 5/8 in for securing appliance panels, trim and small assemblies. Restores proper fastening where original screws are missing, stripped or corroded. What it does

• Cuts its own mating thread in sheet metal or plastic for secure fastening
• Commonly used to attach control panels, trim pieces and small brackets
• Helps stop rattles, loose panels and misaligned trim when original fasteners fail
• Corrosion-resistant finish resists rust in typical laundry appliance environments

• Use the correctly sized screwdriver or driver bit to avoid stripping the head
• Start in a pilot hole if material is brittle or if reinstalling into worn threads
• Do not over-torque; stop when the head seats flush to avoid cracking or stripping
• Disconnect power and follow appliance-specific safety procedures before working

This push button switch mounts in the appliance's control panel and sends an electrical signal to the control when pressed. Replace a worn or sticking switch to restore dependable button response and function activation. What it does:

• Panel-mounted switch that closes its contacts when pressed to signal the control
• Restores reliable front-panel input for starting or selecting a function
• Helps address no response or intermittent response when the button is pressed
• Replaces switches with loose action, sticking, or heat-discolored/burned terminals

• 1 push button switch

• Disconnect power before servicing to avoid electrical shock
• Access the console/control panel to reach the switch
• Note wire positions (take a photo) and transfer connectors one at a time; ensure firm, fully seated terminals
• Secure the switch in the panel (nut/clip as applicable), verify button action, then reassemble and test

This door catch assembly secures the door when closed so the machine can run. A worn or broken catch can keep the door from latching firmly, causing start issues or interruptions during a cycle.

• Engages with the door strike/latch to hold the door shut
• If worn or damaged, the door may not close or stay closed
• Can lead to the unit not starting or stopping mid-cycle when the door moves
• Helps restore proper door latching and safety interlock function

• Unplug the appliance before service
• Open the door and remove fasteners retaining the old catch
• Transfer orientation from the original part to the new catch
• Test door closure and operation before returning to service