Amana Range Blower Wheel Or Fan Blade

Genuine Whirlpool part

Amana Condenser Fan Blade

By: Whirlpool

Part Number: WPW10139483

This condenser fan blade mounts to the fan motor and pulls air across the condenser coil and compressor. Replacing a cracked or warped blade restores airflow so your refrigerator cools efficiently and the compressor runs at a safe temperature.

Circulates air through the condenser coil and over the compressor to remove heat
Helps maintain cooling performance and stable system pressures
Common symptoms: weak or no airflow at the rear/base, rattling or scraping noises, wobble/vibration, visible cracks or missing fins, warmer-than-normal compartments or hot cabinet sides
Works with the condenser fan motor and shroud; typically replaced when the hub is stripped or the blade is damaged

What's included: 1 condenser fan blade Installation notes:

Disconnect power and pull the refrigerator out; remove the rear access cover near the compressor
Note blade orientation and depth on the motor shaft before removal
Pull the old blade straight off; press the new blade onto the shaft until fully seated and ensure it spins freely with proper shroud clearance
Reinstall the cover, restore power, and verify strong, quiet airflow

Do-It-Yourself Stories from Customers like You My customers evaporator was freezing up. Raymond L. • Neptune City , NJ • June 07, 2020

At first, I thought that it was the defrost timer, but when I took apart the freezer, I found that the evaporator fan motor wasn't running, so I replaced it. Read more

More

$44.95

Compare At:: $53.49
You Save:: $8.54

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Amana Convection Fan Blade

By: Whirlpool

Part Number: W10758272

This convection fan blade mounts to the fan motor and circulates hot air during convection cycles. Replacing a bent or damaged blade restores proper airflow, promoting more even temperatures and consistent baking and roasting performance.

Mounts on the convection motor shaft to drive airflow through the oven cavity
Helps maintain uniform temperatures for consistent convection baking/roasting
Typical failure signs: rattling or scraping noises, visible wobble or damaged fins, weak airflow, or the fan not spinning freely
A worn blade can contribute to uneven results in convection mode

What's included: 1 convection fan blade Install notes:

Disconnect power and allow the appliance to cool completely before servicing
Access the blade behind the interior fan cover or rear panel (varies by model); note blade orientation and any spacers/washers for reassembly
Handle sharp edges; avoid bending fins and ensure the blade spins freely without rubbing before restoring power
For microwave/OTR convection units, high-voltage components are present.

More

$10.95