Paul M. for Model Number 665.15784300 I believe that the cause of the low pressure to the sprayer arms may be due to the motor not reversing during the wash cycle. Would this be caused by the Electronic control assembly AP3175633, or is there some other solenoid that could be an issue. The drain cycle works fine and the motor is not loud or making any tell-tail signs of fatigue. Thanks
Answer Hello Paul. You will need to check the impeller WP8274950 and make sure it is good, and the water level inside the tub. If the impeller is bad, you will need to change the seal kit 675703 as well. If the impeller is good, make sure the water is up to the bottom of the heater. If the water is low, you will need to replace the valve W10844024. The board does control the directions of the motor. Hope this helps. Read More... Answered by AppliancePartsPros.com | Tuesday, April 26, 2011