Parts for Frigidaire FEF402BWE: 03 - Backguard Parts

Right-hand end cap bracket for ranges. Secures and protects the end panel. Replace if cracked, broken, or missing to restore structural integrity.

Fix an oven that won't heat, makes noises, or has a non-functioning display with this electronic control board. DIY-friendly repair in under 1 hour.

The Switch Rocker is an OEM part for Frigidaire ranges. This switch is used to control various functions of the range, such as turning on heating elements or activating specific cooking modes. It provides a reliable and straightforward interface for managing the range's features.

You should replace the range switch rocker if it becomes faulty. Causes of a bad switch rocker can include wear and tear from frequent use, exposure to high temperatures, electrical malfunctions, or physical damage from impacts or mishandling. A defective switch rocker can result in unresponsive controls, making it challenging to operate the range effectively.

Symptoms of a bad Range Switch Rocker include:

• The switch not responding when pressed
• Inconsistent or flickering performance of the heating elements
• Physical damage or looseness in the switch
• Intermittent operation or complete failure to activate the desired function

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Replacement control knob for cooktop burner heat settings. Installs on the control panel. Replace if cracked, broken, worn markings, or missing.

Fix a burner stuck on high or not heating with this surface element switch. Controls power to your cooktop heating element. DIY-friendly repair.

Burner won't turn on or heat properly? This range burner control switch restores heat level adjustment. Moderate DIY with wiring terminal labels.

This truss-head machine screw secures a switch to its mounting bracket or panel. Replacing a worn or missing screw restores a solid, aligned switch fit for reliable operation.

• Fastens the switch body to a bracket or chassis panel
• Helps keep the switch aligned for consistent actuation
• Replaces stripped, corroded, or missing mounting hardware
• Common symptoms: loose or wobbly switch, misalignment, rattling or vibration around the switch area

• Disconnect power to the appliance before servicing
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Verify thread size and length match the original hardware
• If multiple screws secure the switch, replace them in a consistent pattern to maintain alignment

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Control panel overlay for electric and gas ranges. Labels buttons and controls on the interface. Replace if cracked, peeling, faded, or worn out.