Parts for Kitchenaid 5KSM3310XEWH0: Base And Pedestal Unit Parts

Replacement mounting screw for stand mixers. Secures panels, brackets, and internal components. Needed when original is missing, stripped, or damaged.

Stand mixer won't start or stops mid-operation? The control assembly manages speed settings and motor operation. Moderate DIY repair in 30-45 minutes.

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

This genuine replacement power cord restores electrical connection to your electric range or oven so the appliance can receive power safely. Designed to replace a damaged or worn cord for reliable operation. What it does:

• Provides the main AC power connection from the wall outlet to the appliance
• Replaces frayed, burned, or damaged cords that can cause intermittent power or sparks
• Helps eliminate loose or unreliable power connections that prevent the oven or range from turning on
• Restores a secure connection when the original cord or plug is cracked or deteriorated

• One replacement power cord

• Disconnect all power at the breaker/fuse and verify power is off before starting work
• Use appropriate strain relief and secure wiring to the terminal block per the appliance wiring diagram
• Inspect the cord and terminal block for damage; replace both if either is compromised

This pedestal serves as the elevating base that raises a front-load laundry appliance for easier loading and unloading, improving ergonomics and creating a stable, elevated footprint. What it does:

• Raises the appliance height to reduce bending and make loading/unloading easier.
• Provides a stable base that helps keep the appliance level during operation.
• Helps protect the appliance underside from spills and floor debris.
• Can improve accessibility when pairing with other laundry storage solutions.

• Disconnect power (and water if applicable) before starting installation.
• Use two people to lift and position the appliance onto the pedestal to avoid injury or damage.
• Align and secure the appliance to the pedestal following the manufacturer's instructions.
• Check level and stability after installation; do not operate an unlevel appliance.

Rubber foot for stand mixers. Installs at the base to provide stability. Replace if worn, cracked, missing, or damaged to prevent mixer movement.

The Idler Shaft Retaining Ring is an OEM replacement part for Whirlpool dryers. Also called an "E" ring, it is a sealing gasket positioned between the front and rear housing omponents. Maintaining an airtight seal prevents gas leakage and promotes efficient drying performance.  

Causes of a bad retaining ring commonly involve compression loss of the rubber gasket material over many years of heating cycles. Exposure to petroleum-based cleaners may prematurely deteriorate the seal as well.

Symptoms of a failed 'E' ring include: 

• Gas leaks emitting foul odors around seams or vents   
• Reduced heat conductivity hampering dryer functioning
• Moisture accumulation shortens fabric lifespan  
•  Drafts compromising indoor air quality and energy bills

This OEM Whirlpool replacement part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore gas dryer models. 

Coated flat beater attachment for 3.5 quart tilt-head stand mixers. Replace your worn, chipped, or missing beater for mixing batters and doughs.

This 6 Wire Whip incorporates air into ingredients for fluffy whipped cream, perfect for frostings and cakes with whipped egg whites. Fits KitchenAid 3.5 Quart Tilt Head models KSM3306, KSM3311, KSM3316, KSM3317, 5KSM3310, 5KSM3311, 7KSM3311, 9KSM3311.

Coated C-dough hook attachment for stand mixers. Mixes and kneads yeast dough efficiently. Replace if worn, damaged, or missing. Top-rack dishwasher safe.

RF filter for stand mixers reduces electromagnetic interference. Replace if mixer causes radio/TV static or fails to start. Verify fit with your model number.