Parts for Jenn-Air JGD8430ADB: 01 - Blower Assembly (Plenum) Parts

This replacement grease filter captures cooking grease and large airborne particles to help protect your hood or microwave exhaust system and reduce buildup on internal components. It restores proper airflow and helps maintain cleaner venting. What it does:

• Traps grease and large particulates from cooking vapors to protect internal fan and ductwork
• Helps reduce visible grease buildup and odors on the hood or microwave interior
• Can improve ventilation performance when a clogged or saturated filter is replaced
• Common symptom: heavy grease coating, reduced exhaust effectiveness, or visibly damaged/soiled filter

• Disconnect power to the appliance before servicing or accessing the filter area
• Follow your appliance owner's manual for filter access and removal instructions
• Typically installs by sliding or snapping into the filter slot behind the grille—verify fit before final installation
• If the filter is washable, clean according to manufacturer recommendations; replace if damaged or excessively clogged

Size: 1 inch.

This blower wheel mounts on the drive motor and pushes air through the dryer drum and out the exhaust. Replacing a worn wheel restores proper airflow for consistent drying and helps prevent overheating and nuisance shutdowns. What it does:

• Moves air across the heater, through the drum, and out the vent to remove moisture
• Helps maintain proper airflow and temperature inside the dryer
• Common failure symptoms: reduced or no airflow at the exterior vent, longer dry times, unusual scraping/thumping or vibration from the blower area, or overheating/shutoff
• Cracked fins or a stripped hub can cause the wheel to slip on the motor shaft

• 1 blower wheel

• Disconnect power and turn off gas supply before servicing
• Access the blower housing per your model's service instructions; remove the retaining hardware and replace the wheel in the same orientation
• Clean lint from the blower housing and vent path; inspect the motor shaft and blower seal for wear
• Reassemble and verify the wheel spins freely without rubbing; check airflow at the exterior vent