Parts for Ge JE635WC03: 02 - Body Parts

This is a light bu, and it is made for microwaves. This is a genuine replacement part made by General Electric. This specific light bu has a voltage of 120 and a wattage of 25.A new light bu might be needed if the current one does not turn on when the microwave door is opened. The light bu should also be on when the microwave is in use so that the user may see the food during the heating cycle. It is common for light bu to burn out over time and they are very easy to replace when needed.This is an OEM part sourced directly from the manufacturer. It is sold individually and is compatible with microwaves made by General Electric.

This thermostat cavity is the molded housing that holds the oven thermostat sensor in place, keeping the sensor positioned for accurate temperature sensing. Replaces a worn or cracked housing to help restore proper sensor alignment. What it does:

• Secures the thermostat sensor/tube so the oven can monitor internal temperature reliably
• Protects the sensor from direct contact with heat sources and food debris
• Helps maintain consistent sensor placement after panel removal or repairs
• Common symptom: oven temperature reads incorrectly or cycles improperly when the housing is damaged

• Disconnect power to the appliance before beginning any repair
• Requires removal of the control panel or rear access panel depending on model; keep fasteners organized
• Handle gently to avoid cracking the new housing; inspect surrounding clips or tabs and replace if broken

This high-voltage diode assembly replaces the diode in a microwave high-voltage circuit to help restore normal heating and high-voltage operation. It provides the one-way conduction needed for the magnetron's high-voltage supply. What it does:

• Converts AC to DC in the microwave high-voltage circuit so the magnetron can produce microwaves
• Commonly associated with weak/no heating or intermittent heating
• Can cause blown high-voltage fuses or arcing if failed
• Prevents reverse current from damaging other high-voltage components

• Disconnect power and discharge the high-voltage capacitor before service to avoid serious shock
• Handle carefully; high-voltage components and terminals can retain charge
• Check related high-voltage components (capacitor, transformer, fuse) for damage when diagnosing

The Primary and Secondary Door Switch is an OEM replacement part for GE microwaves. This part interrupts the power supply to the microwave when the door is opened.   

Causes of bad door switches can include regular wear and tear, electrical malfunctions, or physical damage from slamming the door.  

Symptoms of a bad Primary and Secondary Door Switch include:

• The microwave not starting or operating intermittently
• The appliance operating with the door open
• The interior light not turning on or off appropriately

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Ceramic