Need Help?
Call or text
Dishwasher won't fill or keeps overfilling? The float switch detects water levels for proper filling and draining. Accessible repair in under 30 minutes.
I checked continuity at the float switch since I knew the inlet valve was working when direct wired to 120v. Switch did not have continuity. Replaced switch and inlet valve worked at start of cycle. Read more
Dishwasher overflowing or not filling properly? The float switch monitors water levels and prevents overflow. Watch our video for step-by-step help.
Fix a dishwasher that won't power on or reset with this on/off switch. Replaces worn or moisture-damaged switches. DIY-friendly installation.
Initially performed troubleshooting over the phone with Bosch customer support and did preliminary research on the web. Ultimately had to call out service technician to isolate/confirm problem. He confirmed the problem was most likely the switch (if not, the actually computer processor) and gave me the part number (since it was going to take 10 BD's for him to get the part). I ordered through Appliance Parts Pros and received the part in only 2 days. However, upon trying to install it, I... Read more
Fix a dishwasher that won't start or finish cycles. This soil sensor detects load levels to adjust water and time. Common fix for startup failures.
REPLACED DOOR LATCH AND DOOR LATCH ASSEMBLY. EVERYTHING WORKS AGAIN. Read more
Fix a dishwasher that won't fill or run with a new pressure chamber. Controls water level by sensing pressure. Moderate DIY repair with video guide.
Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more
Soap dispenser door won't open? This dishwasher wax motor actuator controls detergent release. Moderate DIY repair, takes 2 minutes to activate.
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more
Fix a dishwasher that won't start or stops mid-cycle. This door switch detects when the door is closed and signals the control board to begin operation.
I THOUGHT IT WAS THE DOOR SWITCH BECAUSE WHEN I SLAMMED THE DOOR IT WOULD WAKE UP. I FIGURED OUT HOW TO TAKE IT APART AND FOUND ONE BURNT LOOKING TERMINAL AND SAID JACK POT. ORDERED SWITCH FROM YOUR CO. WHICH CAME AMAZINGLY FAST (ONE DAY!) PUT IT BACK TOGETHER. REPAIR MAN ARRIVING SHORTLY Read more
Dishwasher won't start when door closes? Replace a faulty door switch. This normally-open switch activates when the door button is pressed in.
Dishwasher won't start when door closes? This magnetic reed switch detects door position and signals the control. Simple 15-minute DIY replacement.
Fix a dishwasher that won't fill with water or has filling issues. This flow switch controls water entry into the wash cycle. Basic repair.
Usually ships within 4 - 14 days
Fix a dishwasher that won't stop filling or overflows with this float switch. Controls water level during wash cycles. Moderate DIY repair in 30-45 minutes.