Parts for Ge GTUP240EM3WW: 10 - Cabinet (3) Parts

This fork support assembly kit replaces a damaged or worn support that holds and stabilizes the appliance fork/prong component, restoring secure alignment and reliable operation. It's a direct-fit replacement designed to match the original part. What it does:

• Provides structural support and proper positioning for the fork/prong component to prevent sagging or misalignment
• Restores secure attachment so the fork works consistently during normal use
• Helps eliminate symptoms like a loose, shifting, or unstable fork/prong
• Matches OEM fit and function for a straightforward replacement

• One fork support assembly kit

• Disconnect power (and shut off gas if applicable) before attempting service
• Follow the appliance's service manual or OEM instructions for removal and installation
• Basic hand tools are typically required; handle small fasteners and clips carefully

This electronic control board manages the washer's core cycles and settings. When it fails, the machine may not start, respond to inputs, or complete cycles reliably. Replacing it restores proper control of wash operations.

• Directs cycle selection, timing, and motor/valve operations
• Can lead to erratic behavior such as random stopping or incorrect cycle progression
• Intermittent or dead display/indicator response can also indicate a failed board

• Disconnect power before servicing; verify capacitor discharge where applicable
• Handle the board by edges; avoid static damage by using ESD precautions
• Transfer any connectors exactly by position; label wires as needed
• After installation, run a test cycle

Size: 8 - 18 ab.

This is a #8-18 by 5/8-inch Torq II-head screw used to secure appliance panels and components. It provides a reliable fastener option when replacing stripped or missing screws to restore proper fit and reduce vibration or rattling. What it does:

• Secures trim, panels, brackets or small components to appliance frames
• Restores proper alignment and reduces noise from loose parts
• Replaces worn, stripped, or missing fasteners to prevent further damage
• Compatible where an 8-18 thread and 5/8" length with a Torq II-style head are specified

• One screw

• Use the correct Torq II driver bit to avoid cam-out or head damage
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• If replacing rusted or stripped screws, inspect mating threads and replace as needed
• Disconnect power and follow appliance safety instructions before servicing