Parts for Ge PP932EH1ES: Control Panel & Cooktop Parts

Burner won't heat or stays on constantly? The infinite control switch regulates burner temperature. Simple DIY fix with basic tools in under 30 minutes.

Fix a burner stuck on high heat or with no temperature control by replacing the infinite switch. Straightforward DIY repair—remove cooktop screws.

1200W Element Control

Replace your range indicator light when it fails to illuminate. Shows when burners or oven functions are active for safety. Verify fit with your model number.

This hold-down bracket secures a designated component inside your appliance, keeping it firmly anchored during use. Replace a bent, broken, or missing bracket to stop movement and rattling and restore proper alignment and a stable, factory fit. What it d

Burner not heating? This 5.5" radiant element fits beneath glass cooktops. Common fix for non-working burners. Moderate DIY, 20-30 minutes to replace.

Burner won't heat or only inner ring works? This dual radiant element restores both heating zones on your cooktop. Moderate DIY with basic tools.

Mounting bracket that secures the radiant element to your cooktop. Replace if bracket is bent, broken, or missing to properly support the heating element.

Replacement mounting stud for cooktops and ranges. Secures the cooktop assembly to the cabinet or countertop. Replace if broken, stripped, or missing.

This bracket secures the oven/range hot surface indicator light so the indicator stays properly positioned and visible. It restores the light's mounting after breakage or wear, helping you know when a surface or element is hot. What it does:

• Holds the hot surface/indicator light in the correct position behind the console or cooktop lens
• Keeps the indicator light aligned and stable so the hot-surface warning is visible
• Replaces a cracked, bent, or missing bracket that causes a loose or non-seated indicator
• Helps prevent the indicator from rubbing against other components

• One replacement hot light bracket

• Disconnect power to the appliance before starting any repair
• Remove control panel or bezel per your model's service instructions to access the bracket
• Support and align the indicator lamp while fastening the bracket to avoid damaging the bulb or lens

Clear protective tape secures glass panels and components on your cooktop. Replace when tape loses adhesion or during glass panel repairs. Confirm fit.

Mounting plate that secures and supports the wiring harness in your cooktop. Replace if cracked, broken, or missing to properly secure electrical connections.

Conduit wire assembly protects electrical wiring in your cooktop. Replace if the conduit is cracked, damaged, or missing to restore proper wire protection.

ST10-16 X 7/16"

Factory screw secures brackets, panels, trim, or burner components on ranges, cooktops, and wall ovens. Replaces missing, stripped, or corroded fasteners.

Replacement screw for securing panels, brackets, and internal components in ranges, ovens, and cooktops. Replace missing, stripped, or damaged screws.

ST10-16 X 7/16"

Black. 8-18 AB HXW 3/8

This flat washer (.250 inch inner diameter x .812 inch outer diameter) is a simple replacement part that helps distribute load from a fastener and protects mating surfaces for reliable appliance operation. What it does:

• Provides a stable bearing

Retainer wire secures internal cooktop components. Replaces worn, broken, or missing wire that no longer holds parts in proper position.