Parts for Dacor ER36GSCHNG: Control Panel Parts

This service end cap is a chrome-finish replacement trim piece that restores the appliance's finished appearance and protects the exposed end of the control/trim area from dirt and damage. It matches OEM fit and finish for a seamless repair. What it does:

• Covers and protects the exposed end of the control/trim assembly to prevent dirt, moisture, and wear
• Restores the appliance's original appearance where the end cap is cracked, scratched, or missing
• Helps maintain a secure edge on the control/trim area for proper alignment
• Simple cosmetic replacement to improve appearance after panel or control repairs

• One chrome-finish service end cap

• Disconnect power to the appliance before starting any work
• Installation typically involves removing adjacent trim or a few fasteners; handle trim pieces gently to avoid damage
• Align tabs and clips, then press or fasten the end cap into place without forcing

This service indicator light notifies you when the oven needs attention or service, restoring a clear visual alert for troubleshooting and maintenance. It replaces a dim, cracked or non-working indicator so error conditions are easier to spot. What it does:

• Illuminates to indicate a service or fault condition detected by the oven control
• Restores a visible status light when the original lens or lamp is burned out or damaged
• Helps you identify when to consult error codes or schedule service
• Works with the oven control to provide a clear, front-panel alert

• One service indicator light assembly

• Disconnect power to the appliance before starting any work
• Access typically through the control panel; remove trim or panel fasteners as needed
• Handle lens and lamp carefully to avoid damage; replace only with the exact part

This illuminated service knob replaces a worn or damaged control knob to restore a visible, easy-to-use control point on your appliance. It provides the same look and basic control function as the original part. What it does:

• Replaces a damaged or faded control knob so settings can be selected and seen clearly
• Illuminated design improves visibility in low light and matches factory appearance
• Fits the original control shaft and detents for reliable selection feel
• Helps address symptoms like loose, cracked, non-illuminating, or cosmetically worn knobs

• 1 illuminated service knob

• Disconnect power to the appliance before starting any work to avoid shock or injury
• Pull the old knob straight off the control shaft; push the replacement knob onto the shaft until it seats
• If illumination does not work after replacement, verify lamp/LED and wiring with the model-specific service instructions

A single service screw used to secure appliance components such as control boards, brackets, and panels. Replaces worn or missing fasteners to restore proper fit and stop parts from shifting. What it does:

• Secures internal components and mounting brackets to prevent movement and vibration
• Holds control boards, panels, or housings in place for reliable operation
• Helps prevent loose parts that can cause rattling or intermittent contact
• Small, OEM-style fastener sized for precision appliance assemblies

• One service screw

• Disconnect power to the appliance before servicing
• Use the correct screwdriver to avoid stripping the head
• Do not overtighten; snug to manufacturer torque or until secure
• Keep removed screws organized to ensure all are returned during reassembly