Parts for Frigidaire FLCG7522AW0: Control Panel Parts

This is the user interface control board for the washer section of a laundry center. It manages the display panel and button inputs, allowing you to select wash cycles, settings, and start or pause the machine. Replace this board if the washer display is blank, unresponsive, shows error codes, or if button presses are not registering properly.

Unresponsive control panel or display? This user interface wiring harness connects your display to the control board, restoring communication.

The Board Assembly is an OEM part for Frigidaire dryers. This circuit board is for the electronic functions that control drying cycles, settings, sensors, and input/output components.

Causes of a bad board assembly include physical damage from impact or handling, short-circuiting due to intrusion of foreign materials, or naturally occuring component degradation as electronics age. Environmental exposures like moisture over prolonged use can corrode circuitry.

Symptoms of a bad board assembly can include:

• Non-functional cycles
• Inability to select options
• Failure to advance through sequence
• Unresponsive controls/display 

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Replacement console panel for laundry center control assembly. Covers control board and houses buttons. Order new panel if original is cracked or damaged.

Replaces cracked, loose, or broken control knobs on your laundry center. Restores secure temperature and cycle selection for washer and dryer settings.

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic