Parts for Kitchenaid KESS907XSP02: 05 - Control Panel Parts

A replacement refrigerator door gasket that restores a tight seal to the fresh food compartment, helping maintain consistent temperatures and energy efficiency. Fits the factory channel for a direct seal replacement. What it does:

• Seals the fresh food door to prevent cold air loss and reduce temperature fluctuations
• Helps stop frost build-up, condensation, and excessive compressor run time
• Replaces torn, cracked, warped, or flattened seals that no longer seat properly
• Restores proper door closure and reduces energy waste

• Unplug the refrigerator or shut off power before beginning work
• Remove the old gasket and clean the door frame sealing surface before installing the new gasket
• Start by tucking the gasket into the channel at the corners, then work around the door so the gasket seats evenly
• If the gasket is stiff, gently warming with warm (not hot) water or allowing it to rest at room temperature can make installation easier

Replacement mounting screw for ovens and ranges. Secures panels, brackets, and internal components. Order a new screw if yours is stripped, missing, or damaged.

Replace your range vent gasket to seal gaps and prevent heat loss around your oven vent. Install when torn, cracked, or no longer sealing properly.

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit

If your range burner won't heat, cycles incorrectly, or buzzes when turned on, a faulty infinite switch is likely the cause. Moderately easy DIY repair.

Replaces worn, cracked, or unresponsive oven control panel touch pad. Installs on the front control display where buttons are pressed to operate functions.

Replace your range's cracked, broken, or missing control knob. Restores easy setting selection on standard spline-style shafts. Quick DIY fix.

Replace your range's control knob if it's cracked, broken, or missing. This dial installs on the control panel to adjust burner heat and oven settings.

Broken indicator light lens? This red lens covers the control panel light opening, restoring visibility and protection. Easy DIY fix in under an hour.

If your cooktop burner won't heat or won't adjust temperature, the infinite switch likely failed. This part regulates burner power. DIY repair in 30-45 minutes.